Just Better Zeppelin 4-valve Manifold User Manual

Each gauge is individually tested and calibrated prior

to shipment. Due to its sensitivity, the gauge may

need to be "zeroed in" prior to usage.

Adjusting Gauge Recal to Zero

1. Remove lens plug.

2. Turn recal screw slightly in the opposite direction that pointer is to be moved. Maximum recal screw adjustment is 1/2 turn. Over adjustment will permanently destroy calibration.

3. Replace lens plug.

Turn recal screw counterclockwise. Pointer turns clockwise.

Gauges are sensitive instruments.

Over adjustment and/or being subjected to pressures

over dial range are not covered under warranty terms.

Turn recal screw clockwise. Pointer turns counter-clockwise.

REPAIR PARTS

See your wholesaler for a complete line of gauges

REF.

NO. PART NO. DESCRIPTION

1 U1-6B 3/8" Intake

2 U1-4A 1/4" Intake

3 MR-520 Sight Glass

4 MR-605 Piston w/Seat &

O-Rings

5 MR-607 Stem & Nut

6 MR-601 Handwheel & Screw

7 MR-503 Handwheel Screws

(2)

REF.

NO. PART NO. DESCRIPTION

8 MR-509 O-Ring (2)

9 M2-102N Hanging Hook

DEEP VACUUM PUMPS

Heavy Duty,

High Performance

1/2 HP, 60 Cyc Motor

DV-42N 1.5 CFM

DV-85N 3 CFM

DV-142N 5 CFM DV-200N 7 CFM DV-285N 10 CFM

Also Available With

Dual Voltage Motors

Technical service: 800-323-0811

E-Mail: sales@jbind.com

Web Site: www.jbind.com

Featuring

2006 JB Industries Inc.

CHARGING AND TESTING

4-Valve

Manifold

With Free

Floating,

Double O-Ring ,

Piston Seal ,

LIMITED WARRANTY

INSTRUCTIONS PARTS LIST

Directions For Use

Caution: Always consult equipment manufacturer's service manual or instruc tion sheet for recommended procedures.

COMPRESSOR

CONDENSER

RECEIVER

EVAPORATOR

To Observe Closed Closed Closed Closed Back Seated Back Seated

Operating Pressures & Cracked Open & Cracked

To Charge Refrigerant Open Closed Closed Open Back Seated Front Seated Through Suction Valve & Cracked Open

To Charge Oil Open Closed Open Closed Back Seated Front Seated Through Suction Valve

To Charge Liquid Refrigerant Closed Open Closed Open Midway Open Through Discharge Valve

To Build Low Pressure; Open Open Closed Closed Back Seated Midway Open For Control Setting & Cracked Open Or Leak Detecting

To Purge Refrigerant Closed Open Closed Open Back Seated From Discharge Valve & Craked Open

To Evacuate With Open Open Open Closed Midway Open Midway Open Vacuum Pump

A B C D E F

Low Side High Side Port Port Service Valve Service Valve

Blue Red Black Yellow Red Blue

MANIFOLD COMPRESSOR

Evacuation Charging Discharge Suction

Manifold bar has a lifetime warranty, while the components, i.e. gauges, hoses, handles, hose holders, etc. are covered under the limited warranty policy. Products are warranted for a period of one year from date of shipment by JB and limited to repair, replacement or credit, if in our opinion are defective due to workmanship and/or materials. Defective components should be returned to the wholesaler from which the product was purchased for evaluation.

Manifolds are designed for use with all refrigerants except ammonia (R-717). Working pressures are limited to gauge dial range. Use of this manifold under any other conditions voids the warranty.

JB manifolds are designed for use by technically trained AC/R service engineers only. Due to the high pressures encountered in all systems that this manifold will be used on, plus the dangers due to the physical and chemical nature of refrigerants and oils present in all systems, misapplication could result in injury or death.

FORM NO. 25000-308 PRINTED IN U.S.A.

LIMITED WARRANTY

FOR PROFESSIONAL USE ONLY