Just Better 40200 User Manual

40200

Controls Pump with o-ring adapter

Accurately Check controls to 300 PSI of pressure or 25 inches of vacuum

OPERATING INSTRUCTIONS

1. Connect manifold center port charging line to pressure or vacuum port on controls pump depending on type of control you are testing.

2. Connect o-ring end of nger-tight adapter to control capillary’s 1/4” are nut.

3. Connect high or low side chaging line (depending on control pressure range) to the plain end of capillary adapter.

4. Open manifold valve on the side you are using and close the other side. Move controls pump handle up and down developing desired pressure to test and set control. The other manifold valve may be used to bleed o pressure and repeat testing.

Testing Vacuum

REPLACEMENT PARTS

40201 Adapter with o-ring 40202 Adapter o-ring 40203 Vacuum access with valve core 40204 Piston o-ring 40205 35 PSI valve core (pressure) 40206 3 PSI Valve core (vacuum) 40207 Pressure access with valve core

Testing Pressure

Form 40200-300 JB Industries AURORA, IL 60507 USA

84520 40200