Jupio JBC0070 User Manual

GB Jupio All-in-One Charger JBC0070

Introduction

Jupio introduces the first All-in-One Charger󳮁 which features 4 individual charger
channels that can charge four different chemistry batteries at the same time!

The Jupio All-in-One Charger can charge Alkaline, Ni-Cd, Ni-Mh and Lithium batteries.
The following formats are supported: 1.2V Ni-Cd/1.2V Ni-Mh/1.5V Alkaline/4.2V
Lithium AA/AAA/C/D/9V/18650/26650/18500.

The All-in-One Charger has an adjustable sliding contact for variables type of cylindrical
cells, (with a length from 40mm to 67mm)󳮁 . The All-in-One Charger is suitable with
consumer batteries as well as industrial batteries.

For your convenience we have also added 2x 2.1A USB ports to make this charger even
more versatile.

Important safety instructions

Before using the All-in-One Charger, please read and follow these
rules carefully

1. The All-in-One Charger should always be used in a spacious environment, high or

low temperature can impact the batteries performance.

2. Don’t put this product into water.

3. Don’t throw, beat strongly or shake this product, otherwise it may damage the

internal parts and its whole structure.

4. Don’t move the All-in-One Charger close to fire or other sources of heat, in order

to avoid damaging the product.

5. Don’t use sharp metal objects near the All-in-One Charger’s charging and

discharging ports and sliders, otherwise it will cause short circuiting, which will
damage the product.

© 2015 Jupio Europe BV – PO BOX 5105, 9700 GC, Groningen, The Netherlands. www.jupio.com - v1.0

Features of the Jupio All-in-One Charger

The Jupio All-in-One Charger has the following features:

1: Automatic Battery detection: The All-in-One Charger automatically recognizes the
chemistry of a battery.

2: Short-circuit protection: When the All-in-One Charger detects a wrongly inserted
battery the ERROR indicator will start flashing.

3: Defective battery detection: When the battery voltage is too high or too low, the
battery ERROR indicator will start flashing.

4: Slow-Fast Charging: the All-in-One Charger never immediately starts with fast
charging. When the battery has low voltage left the All-in-One Charger starts slowly and
then increases its power gradually. Thus to increase the batterylife.

5: Over Voltage detection: the All-in-One Charger makes sure the battery is never
overcharged.󳮁

6: Temperature protection: When the All-in-One
Charger detects the temperature of the battery is
getting too high it will automatically reduce its
power to lower the temperature. The OVERHEAT
sign will light between 40C and 50C for Lithium
batteries and between 50C and 70C for other
chemistries. When the temperature rises above
the maximum temperatures the charging process
will be stopped automatically.

7: Overcharge time protection: the maximum time allowed for fast charging is: 1 ~ 2
batteries 5Hrs, 3 batteries 7Hrs, 4 batteries 9Hrs .

8. Charging of alkaline batteries. Even though normal alkaline batteries are not
rechargeable the Jupio All-in-One Charger restores these batteries by charging them
with a little bit of electricity.

9. The full charging process of the All-in-One Charger will be displayed in percentages
and voltage on the LCD screen.

© 2015 Jupio Europe BV – PO BOX 5105, 9700 GC, Groningen, The Netherlands. www.jupio.com - v1.0