Junsun Lighting JUNSUN0211 Users Manual

User’s Manual

This light device has been tested and found to comply with the limits for Consumer

RF Lighting device, pursuant to Part 18 of the FCC Rules. These limits are designed

to provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses and can radiate radio frequency energy

and, if not installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation.

1 Use only on 120V/60Hz.

2 Never disassemble or modify-any changes could void the user’ authority to

operate this device.

3 Not for use in totally enclosed recessed fixtures.

4 Risk of electric shock-do not use with where directly exposed to weather.

5 This device is not intended for use with emergency exit fixtures or emergency

exit lights.

6 This product may cause interference to radio equipment and should not be

installed near maritime safety communications equipment or other critical

navigation or communication equipment operating between 0.45-30MHz.

7 To prevent burns, do not touch the bulb burning operation or immediately after

switching off.

8 Not for use with dimmers, electronic timer or photocell devices or occupancy

sensor.

9 It does not start up when placed below -15℃.

10 “Added weight any cause instability of free-standing portable lamps. Use only

with portable lamps in which the distance from the bottom of the base to the

top of the lamp holder does not exceed three (3) times minimum base width.

Use only with portable table lamps which are provided with lamp shades.”