Junlan Electronic SBB55213 User Manual
29 INCH STEREO
29 INCH STEREO
SOUND BAR SYSTEM
SOUND BAR SYSTEM
with Digital Optical Input and
with Digital Optical Input and
®
Bluetooth
Bluetooth
®
Wireless Technology
Wireless Technology
Owner's Manual
PLEASE READ BEFORE OPERATING THIS EQUIPMENT.
Model: CHT985
Size: 148.5(W) x 210(H)mm (A5)
IMPORTANT SAFETY INSTRUCTIONS
FCC Warnings
WARNING:Changes or modifications to this unit
not expressly approved by the party responsible
for compliance could void the user’s authority to
operate the equipment.
NOTE: This equipment has been tested and
found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful interference
in a residential installation. This equipment
generates, uses, and can radiate radio frequency
energy and, if not installed and used in
accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to
radio or television reception, which can be
determined by turning the equipment off and on,
the user is encouraged to try to correct the
interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
•
Increase the separation between the
•
equipment and receiver.
Connect the equipment into an outlet on a
•
circuit different from that to which the receiver
is connected.
Consult the dealer or an experienced radio/TV
•
technician for help.
This equipment should be installed and operated with
minimum distance 20 cm between the radiator and your
body.
FCC NOTICE:
To assure continued compliance, follow the attached
installation instructions and use only shielded cables
when connecting to other devices. Modifications not
authorized by the manufacturer may void user’s
authority to operate this device.
2
IMPORTANT SAFETY INSTRUCTIONS
3
POWER SOURCE
1. Insert the small plug from the supplied AC/DC Adapter to the DC IN Jack on the rear of unit.
2. Connect the AC/DC Adapter to the wall outlet having AC 100-240V~;
50/60Hz.
The Red
Standby Indicator on the front of unit will illuminate.
To the wall outlet
DC IN
DC 5. 8V,1.5A
To the DC IN jack on the rear of the unit.
NOTES:
To save energy, unplug the AC/DC Adaptor from the wall outlet if you may not use the unit
for an extended period of time.
This AC/DC Adaptor intended to be correctly orientated in a vertical or floor mount position.
INSTALLATION
1. Placing on the table
When placing the Sound Bar on an entertainment center, bookshelf, or any type of enclosed
space, be sure to allow at least 2-3 inches of space around the Sound Bar for ventilation. If the
Sound Bar is enclosed in a tight space, without ventilation, heat generated from the Sound Bar
could produce a potential heat hazard.
2-3 inches
2. Mounting the Speaker Bar onto a wall
We recommend having this unit professionally mounted. By using wall mounting accessories
(not included), the unit can be mounted onto a wall.
Distance Between Two Brackets
19.3 inches
AU N
X 1 I
DC IN
DC 5.8V,1.5A
AU N
X 2 I
L R
OPTICAL IN
4
Mounting to a wall
2.1 Mounting to a wooden wall
19.3 inches
A. Mark the position of the mounting screws on the wall using a pencil.
B. Drill the supplied mounting screws directly into the marks that you have made on the wall
and leave approx. 0.3 inches length to hook the sound bar.
C. Put the sound bar onto the mounting screws. Make sure they are firm and stable.
2.2 Mounting to a brick wall
19.3 inches
(
1)
A. Mark the position of the mounting screws on the wall using a pencil.
B. Drill 2 holes on wall with a powerful electric drill.
C. Insert the supplied plastic inserts into the holes by hammer (not included).
D. Secure the supplied mounting screws into the plastic insert and leave approx. 0.3 inch
length to hook the sound bar.
E. Put the sound bar onto the mounting screws. Make sure they are firm and stable.
(2)
5
Loading...