Junlan Electronic JSBW650 User Manual
BLUETOOTH SOUNDBAR SYSTEM
MODEL: JSBW-650
INSTRUCTION MANUAL
Please read this instruction manual carefully and keep it for future reference.
Insert the small plug from supplied AC/DC adaptor to DC IN jack
on the rear of the unit and insert the AC/DC adaptor
to the wall outlet having AC 100-240V~, 50/60 Hz.
NOTE:This AC/DC adapter is intended to be
AC/DC adapter
correctly operated in a vented indoor wall outlet.
To the DC IN jack on the rear of unit.
1. Placing the device on table
Ventilation
When placing the Sound Bar on an entertainment center, bookshelf, or any type of
enclosed space, be sure to allow at least 2-3 inches of space around the Sound Bar
for ventilation. If the Sound Bar is enclosed in a tight space, without ventilation, heat
generated from the Sound Bar could produce a potential heat hazard.
V
O
L
U
ME
A
UX
I
N 2
T
U
N
E
SOU
+
R
C
E
VOLU
M
E
2. Placing on floor in vertical
Fixing the base with the unit body by supplied screw.
Put the unit on flat surface floor.
3
MOUNTING
1. Mounting the device on wooden wall
We recommend having this speaker professionally mounted. By using the included
wall mounting accessories, the sound bar can be mounted onto a wall.
26.9 inches
Holes distance:26.9 inches
in same horizontal level
in same horizontal level
supplied Metallic Bracket
supplied Screws
supplied Metallic Bracket
supplied Screws
1. Mark the position of the mounting screws on the wall using a pencil.
2. Drill the supplied screws directly into the marks that you have made on the wall
with the Metallic Bracket as the figure above.
3. Put the sound bar onto the mounting brackets. Make sure they are firm and stable.
2. Mounting the device on wall
2.2 Mounting on the wooden wall:
Holes distance:26.9 inches
in same horizontal level
supplied Plastic Inserts
supplied Metallic Bracket
(1)
Drill holes by powerful electrical drill.
supplied Screws
(2)
supplied Screws
supplied Plastic Inserts
supplied Metallic Bracket
1. Mark the position of the mounting screws on the wall using a pencil.
2. Drill holes by a powerful electric drill( Not supplied )( Drill head diameter:6.0 mm ).
3. Insert the supplied plastic inserts into the holes by hammer.
4. Secure the supplied screws into the plastic inserts with the Metallic Bracket.
5. Put the sound bar onto the mounting brackets. Make sure they are firm and stable.
4
Loading...