Junlan Electronic CHT978 User Manual

2.1CHANNEL WIRELESS HOME

THEATER SYSTEM WITH 37 INCH

SOUNDBAR

Model:CHT978

IMPORTANT SAFETY INSTRUCTIONS

CAUTION: TO REDUCE THE ELECTRIC SHOCK, DO NOT REMOVE THE COVER (OR BACK). NO USER SERVICEABLE PART INSIDE, REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

DANGEROUS VOLTAGE:The lighting flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may

be of sufficient magnitude to constitute a risk of electric shock to persons.

ATTENTION:The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.

FCC STATEMENT:

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1)This device may not cause harmful interference, and (2)This device must accept any interference received, including interference that may cause undesired operation. The antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.

FCC NOTE:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

"This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20 centimeters between the radiator and your body."

To assure continued operation, follow the attached installation instructions and use only shielded cables when connecting to other devices. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

Warning

-To reduce the risk of fire or electrical shock, do not expose this product to rain or moisture.

-The product must not be exposed to dripping and splashing water and no object filled

with liquids such as a vase of flowers should be placed on the product.

-No naked flame sources such as candles should be placed on the product.

-Batteries (a battery pack or installed batteries) should not be subjected to excessive heat

such as sunshine, fire, etc. Caution:

-Changes or modifications not expressly approved by the manufacturer could void the

user’s authority to operate this device. Caution:

-Usage of controls or adjustments or performance of procedures other than those

specified herein may result in hazardous exposure.

IMPORTANT SAFETY INSTRUCTIONS

Before using the unit, be sure to read all operating instruction carefully, please note that these are general precautions and may not pertain to your unit. For example, this unit may not have the capability to be connected to an outdoor antenna.

1. Read these instructions – All the safety and operating instructions should be read

before the appliance is operated.

2. Keep these instructions – The safety and operating instructions should be kept for

future reference.

3. Heed all warnings – All warnings on the appliance and in the operating instructions should be adhered to.

4. Follow all instructions – All operation and use instructions should be followed.

5. Do not use this apparatus near water – The appliance should not be used near water; for example, near a bath tub, washbowl, kitchen sink, laundry tub, in a wet basement, or near a swimming pool.

6. Clean only with dry cloth – The appliance should be cleaned only as recommended by the manufacturer.

7. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. The appliance should be situated so that its location or position does not interfere with its proper ventilation. For example, the appliance should not be situated on a bed, sofa, rug, or similar surface that may block the ventilation openings; or placed in a built-in installation, such as a bookcase or cabinet that may impede the flow of air through the ventilation openings.

8. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.

9. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades and a third grounding prong. The wide or the third prong are

provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.

10. Product the power cord from being walked on or pinched particularly at plugs,

convenience receptacles, and the point where they exit from the apparatus.

11. Only use attachments / accessories specified by the manufacturer.

12. Use only with a cart, stand, tripod, bracket, or table specified by the

manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.

13. Unplug this apparatus during lightning storms or when unused for long periods of time.

14. Refer all servicing to qualified service personnel. Servicing is required when the

apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.

15. This appliance shall not be exposed to dripping or splashing water and that no object

filled with liquids such as vases shall be placed on the apparatus.

16. Power Sources – The appliance should be connected to a power supply only of the

type described in the operating instructions or as marked on the appliance. Do not overload wall outlet.

17. Battery shall not be exposed to excessive heat such as sunshine, fire or the like.

18. Danger of explosion if battery is incorrectly replaced. Replace only with the same or

equivalent type.

19. Do not attempt to dismantle, open or repair this product yourself. If a fault occurs, seek

advice from your local qualified service technician or contact the distributor via the telephone number at the back of this instruction manual.

20. Caution marking and nameplate are located on back or bottom of product.

POWER SOURCE

1. Insert the plug from the supplied AC/DC Adapter to the DC In Jack on the rear of unit.

2. Insert the small plug from the supplied Adapter to the AC In Jack on the AC/DC

Adapter.

3. Insert the Adapter Plug from the supplied to the wall outlet having AC100-240V~; 50/60Hz.

NOTE: the wall outlet.

If Long period of time will not use the unit, unplug the Adapter Cord from

INSTALLATION

1.The unit can be disassembled into two parts as the figure below:

2.The unit can be re-assembled as the figure below:

PLACING

1. Placing on the table

When placing the Sound Bar and Subwoofer on an entertainment center, bookshelf, or any type of enclosed space, be sure to allow at least 2-3 inches of space around them for ventilation. If they are enclosed in a tight space without ventilation, heat generated from them could produce a potential heat hazard.

MOUNTING

(

)

2.1 Mounting on the wooden wall

You may use

2 pieces screws (Included)

1. Mark the position of the mounting screws on the wall using a pencil.

2. Drill the supplied screws directly into the marks that you have made on the wall and leave approx. 0.3 inch length to hook the sound bar.

3. Put the sound bar onto the mounting screws. Make sure they are firm and stable.

2.2 Mounting on the concrete/brick wall

You may use

2piecesscrews (Included)

1. Mark the position of the mounting screws on the wall using a pencil.

2. Drill 2 x 7/32 inch diameter holes by a powerful electric drill ( Not Supplied ).

3. Insert the supplied plastic inserts into the holes by hammer ( Not Supplied ).

4. Secure the supplied screws into the plastic insert and leave approx. 0.3 inch length to hook the sound bar.

5. Put the sound bar onto the mounting screws. Make sure they are firm and stable.

2 pieces plastic inserts

Included

+ 12 hidden pages