Juniper Systems XF101 User Manual
Technical Details:
Factory Settings:
The following information is provided for
users familiar with Hemisphere GPS
commands. For more information on specifi c
commands, please consult the Hemisphere
GPS Technical Reference. This document can
be downloaded at www.hemispheregps.com.
The following confi guration commands are
sent at the factory:
$JOFF•
$JWAASUDRE,13,13•
$JMODE,SBASR,YES•
$JMASK,3•
$JALT,SATS,4•
$JASC,GPGGA,1,PORTA•
$JASC,GPGSA,1,PORTA•
$JASC,GPGSV,.2,PORTA•
$JASC,GPVTG,1,PORTA•
$JBAUD,57600,PORTA,SAVE•
The XF101 is confi gurable. The following settings are the standard factory confi gurations.
These are the settings that Hemisphere GPS
recommends using.
Port to access GPS COM2
Default baud rate 57600
Messages GPGGA (1 Hz)
GPGSA (1 Hz)
GPVTG (1 Hz)
GPGSV (5 sec.)
Indicator:
The LED on the top left corner is red when the
GPS has power.
© Hemisphere GPS (2009). All rights reserved.
Hemisphere GPS®, and the Hemisphere GPS logo are propietary trademarks of Hemisphere GPS. Other trademarks are
the properties of their respective owners.
Contact Information:
precision@hemispheregps.com
XF101 DGPS Reveiver
Quick Reference Guide
Part Number 875-0234-000 Rev. A1
Add a new GPS receiver to a Windows
Mobile PC with a XF101 DGPS receiver.
®
Handheld PDA
Installation
Always power off the PDA before 1.
attaching or removing the GPS receiver.
Remove the two screws on the top cover 2.
of the handheld PDA.
Interface module
Align the compact fl ash card with slot.3.
Insert the interface module carefully. 4.
Be sure you feel NO resistance when
sliding the parts together. If you do, slide
the pieces apart and try again.
Tighten the screws. This connection 5.
keeps water out of the handheld PDA.
GPS module
Align GPS module with the interface 6.
module.
Connect the GPS module and the inter-7.
face module.
Fold in the screw tabs.8.
Tighten the screws.9.
Loading...