Juniper Systems USB Power Dock Pogo Pin User Manual

Dock. Your Power Dock is now ready for use again.

pogo pins are installed.

pin to slide it all of the way into the pin holder.

Repairing the USB Power Dock

Occasionally the USB/Power Dock may need to be
returned for repair because of problems that cannot be
corrected by you. The following are situations where
you will need to return the USB/Power Dock:

1. A pogo pin socket is bent or loose.

2. A pogo pin has broken off in the socket and cannot
be pulled out.

6. Reconnect the power and USB cables to the Power

5. Now repeat the previous steps until all the new

4. Using your fingernail, push on the edge of the pogo

Allegro CE USB/Power Dock
Pogo Pin Replacment

These instructions show you how to replace the
connector pins in the USB/Power Dock. There are six
pins in each Power Dock that are the conductors for
connecting the Allegro CE to the Power Dock. These
pins need to be replaced if bent,
broken, or otherwise damaged.

empty pin slot.

3. Using your fingers, place the new pogo pin into the

pin out.
portion of the pogp pin socket when you pull the
pull it straight out. Do Not grasp the protruding

2. Using the needle nose pliers, grasp a pogo pin and

cut here

Contact the company you purchased the USB/Power
Dock from or Juniper Systems, Inc. directly for
instructions on how to return the unit.

a Campbell Scientific Company

1740 North Research Park Way Phone: [phone]
Logan, UT 84341-1977 USA E-mail: [e-mail]

Release Date: November 2002

Document Number: 13196-00

Items Needed:

- Needle nose pliers

- Six gold plated popo pins
(in bag)

To replace the pogo pins
complete the following steps:

1. Unplug the power cable and
the USB cable from the Power
Dock.

Part # 13055-00

cut here