Juniper Systems Mesa Bumper kit User Manual

bumperkit

replacement instructions

P/N: 23071.00 Copyright September 2011, Juniper Systems,
Inc. Information is subject to change without notice. Juniper
Systems and Mesa Rugged Notepad are trademarks of Juniper
Systems, Inc.

Contents of Bumper Replacement Kit

The Mesa Rugged Notepad bumper
replacement kit includes the following items:

 Standard Mesa: One bumper for the

top and one bumper for the bottom
(interchangeable)

 Geo Mesa: One extended antenna

bumper for the top and one bumper for
the bottom,

 Eight screws

 Screwdriver

 Instruction sheet

Replacement Instructions

1. Suspend or power off the Mesa.

2. If a hand strap is attached to the Mesa,
remove it.

4. Carefully remove the bumpers.

Note: If you have a Geo model (shown

in above graphic), use caution while
removing and installing the top
extended antenna bumper to avoid
damaging the antenna assembly.

5. Place the new bumpers into position,
making sure the screw holes line up on
the sides.

6. Insert and screw in 8 screws (2 on each
corner as shown in step 3) to attach the
new top and bottom bumpers to the
Mesa.

tel: [phone]

1132 W. 1700 N. Logan, UT 84321

web: www.junipersys.com

l

3. Remove the 8 screws (2 on each corner
as shown) that attach the top and
bottom bumpers to the Mesa.

7. Reattach the hand strap in the desired

location.