Juniper Systems Bumper kit Archer 2 User Manual

bumperkit

replacement instructions

Contents of Bumper Replacement Kit

The Archer2 bumper replacement kit
includes the following items:

 Standard Archer

2

: One bumper for the

top and one bumper for the bottom

 Barcode Archer

2

: One top bumper with a
viewing window for the barcode reader
and one bumper for the bottom

 Instruction sheet

Removing the Bumpers

1. Pull one front corner of the bumper
away from the unit.

2. Pull the bumper off the unit.

Installing the Bumpers

2. Push the bumper down so that the nub is
inserted into the mating hole.

3. Press the rst back corner of the bumper
into the Archer2.

4. Press along the front and back edges
of the bumper to seat them into the
Archer2.

5. Press the second back corner into the

2

Archer

.

6. With the rest of the bumper seated, lift
and fold back the second front corner
of the bumper to expose the nub on the
inside of the corner.

P/N: 24079.00 Copyright December 2013, Juniper Systems, Inc.
Information is subject to change without notice. Juniper Sys­tems and Archer2 are trademarks of Juniper Systems, Inc.

Note: The Archer2 bumpers are designed
with a small nub inside the corner of the

bumper. This must t inside the mating

hole on the Archer

2

. Note: Color added for

highlighting

1. Place one front corner of the bumper
slightly above the front corner of the
Archer

2

as seen in the gure.

7. Pull and stretch the bumper so that the
front corner can be positioned slightly
above the second front corner of the
Archer

2

.

8. Once positioned, insert the nub into the
mating hole.

9. Remove and replace the remaining
bumper in the same manner.

tel: [phone]

1132 W. 1700 N. Logan, UT 84321

web: www.junipersys.com

l