Juniper Systems Archer 2 Quick Start

Bumper Barcode Window (opt)

Handstrap Tether

Touchscreen Camera Lens (opt)

Microphone Camera Flash/Flashlight (opt)

Speaker

Battery Pack SIM & SD Card Slots

Battery Door
Screws

Handstrap

Connector Module 9-pin Serial Por t

12-24VDC JackUSB Client

Microphone/Speaker Jack USB Host

Stylus

Power Button &

LED Indicators

Perform Initial Tasks

1 Loosen the 4 captive screws on the battery door with a #1 Phillips screwdriver. Remove the door.
CAUTION: The handheld is not sealed when the door is removed.

2 Place the battery pack into the compartment. Be sure to line up the and .
3 Replace the batter y door and tighten the screws.
4 Plug the AC power charger into a wall socket and the DC jack on the handheld.
5 The handheld powers on and several screens appear. When the Time screen is shown make adjustments if

needed and select OK.

6 Charge the batter y pack at room temperature for 5 hours.

The operating system, manual and quick start guide is available in English, Spanish, French, German,
and Brazilian Portuguese. Go to our website at www.junipersys.com/Archer-2/support.

© 2014 Juni per System s, Inc. Al l rights re served. A rcher 2 is a t rademar k of Junip er Systems, I nc. Part N umber: 2 3412-01