Juniper Systems Allegro Top Mounting Bracket User Manual

Installing the Top Mount Bracket on the Allegro

The top mount bracket for the Juniper Systems Allegro can be used
in a variety of mounting applications. Originally designed for a GPS
antenna mated with a separate GPS receiver system, it can also be
used with Bluetooth devices like barcode scanners, RFID readers, and
standalone GPS devices.

Installing the top mount bracket on the Allegro is a simple seven-step
process. To complete this, you will need a thin, narrow, metal object.
Caution: Do not use a sharp knife as this could damage the case.

1. Remove the existing on-board stylus from the top of the Allegro.

Figure 1: Remove stylus from Allegro

2. Loosen the thumbscrews on the bracket until the nuts reach the
top of the threads. It is not necessary to remove the nuts.

Figure 2: Loosen thumbscrews.

3. Place the mount in position at the top of the Allegro with the

at face of the mount close to the same plane as the Allegro’s

display. See Figure 3.

Figure 3: Align mounting surface as close as possible to display.

Rotate bracket into position.

4. Rotate the stylus on the mount into place on the Allegro. This will
allow the edge of the small metal bracket to catch the plastic
edge of the stylus receptacle.

5. Hold the stylus rmly in place as you use a thin, narrow, metal
object to work the rubber tabs around the stylus. Do not cut the
rubber tabs.

6. Position the tabs of the larger bracket so that they will go into the
screw holes on the underside of the Allegro.

Figure 4: Position tabs into screw holes (right side shown)

7. Tighten the thumbscrews until the mounting bracket is secure.

Your bracket is now ready for use.

1132 West 1700 North

Logan, Utah, 84321-1723

Phone: [phone]

Fax: [phone]

Document P/N: 12856-03

Release date: July 2011

E-mail: [e-mail]

Web page: www.junipersys.com