JumpSport Fitness Trampoline, 300 Series User Manual

Fitness Trampoline™ User’s Manual

Assembly, Installation, Care, Maintenance, and Use Instructions

DO NOT attempt or allow
somersaults. Landing on the
head or neck can cause
serious injury, paralysis or
death, even when landing in
the middle of the bed.

Read these materials prior to assembling

and using this rebounder trampoline

Use trampoline only with mature, knowledgeable supervision.

WARNING

DO NOT allow more than one
person on the trampoline.
Use by more than one person
at the same time can result in
serious injury.

• WARNING: Users should consult with a physician before beginning any exercise or conditioning program.

• If user feels faint or dizzy, immediately stop using the rebounder trampoline.

• Avoid bouncing when tired. Take breaks often.

• Use only in a well lit area by responsible, mature, non-intoxicated persons.

• Only use trampoline on a level surface, and only use when dry.

• Keep away from objects which could interfere with safe use. Clear obstructions underneath, above, or around the

rebounder trampoline. Check for adequate vertical clearance (avoid low ceilings, ceiling fans, light fixtures, etc.) and
lateral clearance (avoid furniture, lamps, walls, other trampolines, etc.).

• Inspect before each use. Replace or adjust any loose, worn, defective, or missing parts.

• Do not jump on and off the trampoline. Do not use the trampoline as a springboard to or from other objects. Do not

step on the frame when getting on and off the trampoline.

• Stop bounce by flexing knees as feet come in contact with the trampoline bed. Learn this skill before attempting
other more advanced moves. Control is more important than bounce height.

• For information concerning skill training, contact a qualified fitness trampoline instructor.

• Store and protect trampoline from unauthorized use.

• For additional information, contact us at JumpSport.com or 1-877-507-1399.

It is the responsibility of the purchaser to become familiar with all of the information in this booklet, to convey the warnings to all

Commercial Use

Only models in our 300 Series are for commercial use, and are subject to shorter warranty periods (see Warranty section).
Stacking:

Use 2 people when stacking or unstacking units. Stack 8 units max, with feet down.

users, and to enforce JumpSport’s rules for safe use.

** Unfolding/Folding the Trampoline **

WARNING: When
folding and unfolding
the trampoline, keep
head and face away
from frame at all
times. Failure to do so
can cause serious
injury to head or face,
or lead to other
serious injuries.

(Centerline of mat)

To unfold/fold your trampoline:

• Lay the trampoline upside down and flat on the ground.

• Place both knees near the center of the mat without them going past the center line, about shoulder-width apart, and with the

hinges directly to the left and right of you. Place hands on top side of frame (also about shoulder-width apart), and slowly push

the frame open, or slowly pull it closed.

• After the trampoline is fully opened, adjust the elastic cords to make sure they are all evenly spaced around the frame.

Note: When folding the trampoline c losed, be sure t o remove the exercise handle bar an d legs (if any are installed), following the
instructions for installing them in reverse order.

IMPORTANT: Be careful to hold the frame securely and ease it shut as it closes.

Retain address information for future use.

Retain address information for future use.

JumpSport, Inc.
2055 South 7th Street, Suite A
San Jose, CA 95112 U.S.A.

www.fitnesstrampoline.com

1-877-507-1399

(Pictures are for illustration purposes only and may not match actual product.)

U.S. Patent No. 6,840,891. Additional Patents Pending.

Instruction Manual P/N: INS-P-20487-00B

Copyright © 2003-2011, by JumpSport, Inc. All rights reserved.

1

** Installing Leg Pieces **

6mm Allen wrench

TOO-P-20334-00

(not shown)

TOO-P-20320-00

(Leg socket)

Leg screw

Leg

LEG-A-20159-02

6mm Hex drill bit

Leg cap

CAP-P-11678A

(may not be pre-

installed)

1) Familiarize yourself with the leg pieces (leg and leg cap), leg screw, and the Allen wrench/drill bit.

IMPORTANT: Be sure leg caps are installed securely over bottom of l egs, as shown above.

Notch in leg socket

Pin on stud

WARNING: Periodically check
all leg screws and retighten if
necessary. All leg screws
should be tight prior to using
the rebounder trampoline.

Note: Keep Allen wrench to remove
or re-tighten legs, as needed.

2) If you are going to install an exercise handle, see next page for handle leg placement before installing the legs in this step.

With trampoline upside-down, fit leg sockets over stud on trampoline frame. Notch in leg socket lines up with pin on stud. If
planning to fold and store your trampoline after each use, securely tighten leg screws by hand. If you are not planning to fold and
store the trampoline after each use, securely tighten leg screws with supplied 6mm Allen wrench.

The JumpSport Fitness Trampoline is now ready for use!

If you have an exercise handle bar, continue to the next page for installation instructions.

2

** Installing Exercise Handle Bar **

Handle legs

LEG-A-20167-00

WARNING: If you have handle
legs attached, do NOT attempt to
use the rebounder without the rest
of the handle pieces properly
installed first.

1) The 2 handle legs will be installed in place of the normal legs at the 2 locations shown above. Turn trampoline upside-down, fit leg

socket over stud on trampoline frame, and tighten bolts. Be sure the Fitness Trampoline logo is centered between the 2 handle legs.

Top handle

HAN-A-20164-00

CAUTION

Avoid Injury.

Exercise handle bar (when
attached to the rebounder) is
not designed to support your
entire weight. It is to aid
with balance and provide
exercise versatility.

2) Connect side handles to top handle, and secure with small

thumb screws to create a “top assembly”.

3) Lower top assembly into handle legs. You may have to

rotate entire top assembly 180 degrees for holes to line up. Adjust

height as necessary, before securing with large thumb screws.

Your exercise handle bar

is now installed!

To remove the handle, follow the installation

instructions in reverse order.

Right side

handle

HAN-P-20169-00

Small thumb screws

SCR-P-11706A

Left side

handle

HAN-P-20170-00

Large thumb

screws

SCR-P-11707A

3

** How to Adjust FlexBounce™ Cords **

(if applicable)

If you wish to change the
firmness of your rebounder,
turn it upside down. Then
pull cord tighter to different
knot, according to chart. See
picture for firmness settings.

FlexBounce III = 3 knot cord

FlexBounce VII = 4 knot cord

Softer

Firmer

FlexBounce III Configurations FlexBounce VII Configurations

Soft Setting on all FlexBounce connectors Soft Setting on all FlexBounce connectors

Medium Setting on every other connector Medium Setting on every other connector
Soft / Medium / Medium Settings (repeat pattern)
Medium Setting on every connector Medium Setting on every connector
Firm Setting on every other connector
Medium / Firm / Firm Settings (repeat pattern)
Firm Setting on every connector

Soft Setting

(factory setting)

FlexBounce VII

shown here

(3 settings,

7 configurati ons)

Medium

Setting

FlexBounce

connector

Firm

Setting

Softer

Firmer

CAUTION: Pinch Point.

Avoid touching hinges directly.

1 hinge points up towards

the 12 o’clock position

** Use Instructions **

WARNING: Frame can snap
shut when resting on it's side when
hinges are not in a vertical
position.

If the trampoline is ever going to be held or used in a position where all 6 legs are not sitting flat on the same ground together, be sure
to orient the trampoline so that one of the hinges is pointing straight up into the air towards the 12 o’clock position. This will help
prevent the trampoline from folding or closing unexpectedly while under pressure.

4

Limited Warranty

What is covered by this warranty? This warranty covers a one-time replacement of any defects in materials or

workmanship on all of the components of the JumpSport Fitness Trampoline, and is extended exclusively to the original retail
purchaser.

How long does this coverage last? Warranty coverage for each component begins from the original date of purchase and

lasts as follows:

Steel Frame & Legs Lifetime 5 years
Jumping Surface 5 years 1 year
EnduroLast 2 Elastic Cords 2 years n/a
EnduroLast 4 Elastic Cords 4 years 12 months
EnduroLast 6 Elastic Cords 6 years 18 months
All other components 1 year 1 year

Private Use

What will JumpSport do? If you return the defective part to JumpSport, as instructed below, JumpSport will either repair or

replace such part, at JumpSport’s discretion, and return it to you.

What is not covered by this warranty? This warranty does not cover expenses of on-site labor, shipping costs, travel,

assembly or disassembly, or other charges associated with the repair or replacement of covered components. This warranty
also does not cover any problem that is caused by abuse, misuse, commercial or public use of 200 Series models, ordinary wear
and tear, outdoor use, weathering, acts of God (such as wind and lightning), failure to follow directions, improper installation,
improper maintenance, or any silk screened graphics. Rust is a natural occurrence with any steel product and is likewise not
covered by this warranty, to the extent that it does not affect the structural integrity of the part.

JUMPSPORT IS NOT RESPONSIBLE OR LIABLE FOR INDIRECT, SPECIAL, OR CONSEQUENTIAL DAMAGES ARISING
OUT OF OR IN CONNECTION WITH THE USE OR PERFORMANCE OF THE PRODUCT OR OTHER DAMAGES WITH
RESPECT TO ANY LOSS, INCLUDING BUT NOT LIMITED TO ECONOMIC LOSS, LOSS OF PROPERTY, LOSS OF
REVENUE OR PROFITS, LOSS OF ENJOYMENT OR USE, COST OF REMOVAL, INSTALLATION OR OTHER
CONSEQUENTIAL DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR
CONSEQUENTIAL DAMAGES. ACCORDINGLY, THE ABOVE LIMITATION MAY NOT APPLY TO YOU.

THE WARRANTY EXTENDED HEREUNDER IS IN LIEU OF ALL OTHER WARRANTIES AND ANY IMPLIED WARRANTY
OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE IS LIMITED IN ITS SCOPE AND DURATION TO
THE TERMS SET FORTH HEREIN. SOME STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED
WARRANTY LASTS. ACCORDINGLY, THE ABOVE LIMITATION MAY NOT APPLY TO YOU.

How to get a defective part replaced:

1) Call the JumpSport Customer Service department at 1-877-507-1399 to obtain a Return Authorization number. All returns
must be pre-authorized.

2) Send the part(s) to the designated Service Center, along with a copy of your original sales receipt and a brief written
description of the problem, including how it occurred. You must pay freight and insurance to return the part to Jump­Sport. At JumpSport’s sole discretion, we may ask you to send photographs in addition to or in lieu of returning the part.

3) After inspecting the returned part(s), JumpSport will make a final determination whether the part is covered by this
warranty. We reserve the right to examine photographs or physical evidence concerning parts claimed to be defective prior
to making a final determination concerning the claim. A repaired or replacement part will be returned to you. Please allow
3 to 4 weeks for delivery.

This warranty gives you specific legal rights. You may also have other rights which vary from state to state.

* Only the models in our 300 Series of Fitness Trampolines are approved for commercial use. When used in a commercial
setting, the commercial warranty applies.

Commercial Use

(300 Series only)

5

2055 South 7th Street, Suite A

JumpSport, Inc.

San Jose, CA 95112

1-877-507-1399

http://www.fitnesstrampoline.com

6