Jump n Carry 300, 400, 660, 950, 4000 Instructions Manual

...
Jump-N-Carry
®
Models 300, 400, 660, 950, 4000 & 12/24
Charge the Jump-N-Carry®for 24 hours upon opening the box.
The unit must be fully charged before use or long-term storage.
842-355-001
This unit contains a sealed, non-spillable lead-acid battery, which must be recycled. Consult your local
government concerning regulations for proper disposal. See Battery Replacement section.
Pb
2
1. Read these instructions completely before using the product and save them for future reference.
2. WARNING: POSSIBLE EXPLOSION HAZARD — WORKING AROUND LEAD-ACID BATTERIES MAY BE DANGEROUS. LEAD ACID BATTERIES RELEASE EXPLOSIVE GASES DURING NORMAL OPERATION, CHARGING, AND JUMP-STARTING. CAREFULLY READ AND FOLLOW THESE INSTRUCTIONS FOR SAFE USE. ALWAYS FOLLOW THE SPECIFIC INSTRUCTIONS IN THIS MANUAL AND ON THE JUMP-N-CARRY®EACH TIME YOU JUMP-START USING THE JUMP-N-CARRY®.
3. Before using the Jump-N-Carry
®
to jump-start a car, truck, boat or to power any equipment, read these instructions and the instruction manual/safety information provided by the car, truck, boat or equipment manufacturer. Following all manufacturers’ instructions and safety procedures will reduce the risk of accident.
4. General precautions for use:
Always wear eye protection and appropriate protective clothing when working near lead-acid batteries. Do not touch eyes while working on or around lead-acid batter­ies.
Never work alone with electrical equipment. Make sure that someone is around to give assistance if you need help.
Always store, use, and charge the Jump-N-Carry®in an area where children cannot get to the unit.
The clamps of the Jump-N-Carry®portable jump-start system may cause sparks if touched together. Always keep the clamps secured around Clamp Lock arms to prevent sparking.
The charger uses household 115 volt electrical supply, which if misused, may cause injury or fire.
All lead-acid batteries (car, truck, and boat) produce hydrogen gas which may vio­lently explode in the presence of fire or sparks. Do not smoke, use matches or a cig­arette lighter while near batteries. Do not handle the battery while wearing vinyl clothing because static electricity sparks are generated when vinyl clothing is rubbed.
Use the Jump-N-Carry
®
to charge/jump-start lead-acid batteries only. Do not use the
unit to recharge dry cell batteries.
•Remove jewelry such as rings, bracelets, necklaces and watches when working around a battery. A lead acid battery can produce a short circuit current, which can melt metals and result in a severe burn.
Do not drop tools or other metal objects on or near the battery as a spark may result, igniting explosive gases.
Do not jump-start or attempt to recharge a frozen battery.
WARNING: While the battery in the Jump-N-Carry®is a sealed unit with no free liquid acid, batteries being jump-started with the Jump-N-Carry®unit likely contain liquid acids which are hazardous if spilled.
Safety Information
3
WARNING: Failure to follow instructions may cause damage or explosion, always shield eyes. Read this entire instruction manual before use.
1) Use in a well ventilated area. Shield eyes with safety glasses or goggles.
2) Turn off the ignition before making cable connections.
3) Do not touch the RED POS (+) clamp to the BLACK NEG (–) clamp.
4) First connect the RED POS (+) clamp to the POS (+) battery terminal, then connect the BLACK NEG (–) clamp to the engine ground, or a non-moving metal engine part. Stay clear of batteries while jump starting.
NOTE: A good, solid and clean connection is essential for a successful jump start (see Performance and Temperature section).
5) After starting, disconnect the BLACK NEG (–) clamp first, then the RED POS (+) clamp.
6) Always return the jumper cables to the cable holders after use.
7) After use, recharge the Jump-N-Carry
®
(see Recharging Jump-N-Carry® section).
When jump-starting, do not use the unit for more than 6 seconds without a 3 minute rest period between use. See the warranty for important details.
To ensure trouble-free use, please remember to recharge the unit for 24 hours at least once every 3 months during the winter, and monthly during the summer (see Recharging
Jump-N-Carry
®
section).
WARNING: Failure to follow instructions may cause damage or explosion, always shield eyes. Read entire instruction manual before use.
WARNING: Prior to jump-starting a vehicle, visually confirm that the unit is in the same voltage mode (12 volt or 24 volt) as the vehicle to be jump-started. Improper voltage selection may cause damage or explosion.
1) Use in a well ventilated area. Shield eyes with safety glasses or goggles.
2) Plug the voltage selector cable into the proper socket for:
12 volt charging system vehicles in the 12 volt Mode 24 volt charging system vehicles in the 24 volt Mode
3) Turn ignition off before making cable connections.
4) During nighttime use turn the emergency light on to identify the positive and nega­tive battery terminals.
5) Do not touch the RED POS (+) clamp to the BLACK NEG (–) clamp.
6) First connect the RED POS (+) clamp to the POS (+) battery terminal, then connect the BLACK NEG (–) clamp to the engine ground, or a non-moving metal engine part. Stay clear of batteries while jump starting.
NOTE: A good, solid and clean connection is essential for a successful jump start (see Performance and Temperature section).
7) After starting, disconnect the BLACK NEG (–) clamp first, then the RED POS (+) clamp.
8) Always return the jumper cables to the cable holders after use.
9) After use, recharge the Jump-N-Carry
®
(see Recharging Jump-N-Carry® section).
When jump-starting, do not use the unit for more than 6 seconds without a 3 minute rest period between use. See the warranty for important details.
To ensure trouble-free use, please remember to recharge the unit for 24 hours at least once every 3 months during the winter, and monthly during the summer (see Recharging
Jump-N-Carry
®
section).
Jump-Starting Instructions:
Models 300, 400, 660, 950 & 4000 Only
Jump-Starting Instructions: Model 12/24 Only
Loading...
+ 5 hidden pages