Hanging Set
Got a Problem building your Hanging set or request a full
range of accessories and replacement parts. Please call
0344 800 4060 or visit our website at: www.jumpking.eu
BACKYARD
1
. WARNING! ADULT SUPERVISION & GUIDANCE REQUIRED AT ALL TIMES.
. Recommended age 3+ years.
WARNINGS!
. The following product dimensions:
IMPORTANT INFORMATION
- Height from ground to top: 206 cm (2.06m)
- Length: 220 cm (2.20m)
- Depth: 205 cm (2.05m)
2
. Only for domestic use.
. Maximum user weight limit 45kg.
. Not suitable for children under 3 years - small parts, choking hazard.
. Long cord – Strangulation hazard.
. ONLY for residential outdoor use only.
. The UFO frame is a conductor of electricity. Lights, extension leads and all other electrical
equipment must never come into contact with the swing.
. The product must be assembled by an adult and erected in accordance with assembly
instructions.
. Only one user. Collision hazard.
. Do not use in strong wind condition
. The related product must be placed on a level surface at least 2m from any structures or
obstructions such as fence, garage, house, overhanging branches, laundry lines or electri cal wires.
. DO NOT install the product over concrete, asphalt or any other hard surface and not in the
proximity of other conflicting instillation such as paddling / swimming pools, swings, slides
or climbing frames.
. Inspect the product before each use. Any damaged or worn parts must be replaced before
using the product.
. Make sure there are no children / animals / obstructions underneath the product. Please
don’t use when it’s windy or rainy as this can cause you to slip and become injured.
PART
All Parts
(Tubing and
screws)
Clips
Hanging seat and
ropes
CHECKLIST
Securely attached
Correctly positioned
No sharp edges or points present
No missing parts
No damage (bent / broken)
No missing parts
No bent parts
No damage
No rusting or corrosion
NOT OKOK
CARE & MAINTENANCE
Regular care and maintenance of your product is required. This will help prolong its life and reduce the
possibility of injury. Neglecting this can lead to a risk for users.
Inspect your product before each use using the checklist below as a guide. Take particular care in
doing this at the start of each season and at regular intervals. Ensure all parts are intact and cannot
become dislodged during play, tighten any screws or nuts and bolts where required.
IMPORTANT: If any faults are found, the product MUST NOT BE USED. We advise that the product is
dismantled and placed in a dry place until new parts are fitted.
Take care when moving the product. To be lifted by 2 people. Lift slightly off the ground, keep the
frame horizontal. Never drag to move it as this can displace parts. Always check that parts are positioned correctly after moving.
3
Description:
Safety glasses
Description:
Allen Key (Included)
Description:
Mallet
Description:
Gloves
1. This is a 2 person build.
2. Time for build is approximately 1 hour.
3. Choose a good location:
Suggest on a level surface that is soft
(wood chippings, sand or grass).
(7.3m) from ground level, away from
wires, trees and other possible hazards.
(2.5m) around sides, away from walls, fences, structures, tarmac
and other hard surfaces and play areas.
BUILDING YOUR UFO SWING SET
WHAT YOU WILL NEED
4
PARTS LIST
Part 5
Part 9
Part 10 Part 11
Part 13
Part 14
Part 15 Part 16
Part 6 Part 7 Part 8
Part 2
Part1
Part 3
Part 4
Description:
Top frame
Quantity: 1 pc
Description:
Foot pad
Quantity: 4 pcs
Description:
Bottom straight pole
(A marking)
Quantity: 2 pcs
Description:
Bottom straight pole
(B marking)
Quantity: 2 pcs
Description:
Bottom straight pole
(C marking)
Quantity: 2 pcs
Description:
Bottom straight pole
(D marking)
Quantity: 2 pcs
Description:
Top Curve pole
Quantity: 4 pcs
Description:
Bottom curve pole
Quantity: 4 pcs
Description:
Jumpking logo
sticker
Quantity: 2 pcs
Description:
Ropes
Quantity: 1 set
Description:
55mm Screw (A)
Quantity: 4 pcs
Description:
50mm Screw (C)
Quantity: 4 pcs
Description:
Hanging seat
Quantity: 1 pc
Description:
Hanging seat top rail
Quantity: 4 pcs
Description:
45mm Screw (B)
Quantity: 4 pcs
Part 12
Description:
6mm Screw (D)
Quantity: 12 pcs
5
PARTS LIST
Part 20
Part 19Part 18
6
Description:
Metal peg
Quantity: 8 pcs
Description:
Expandable screw
Quantity: 4 pcs
Part 17
Description:
Clip
Quantity: 2 pcs
Description:
Screw set for
Hanging seat toprail
Quantity: 4 sets
Assemble the frame according to below diagram:
Make sure the metal pegs insert into ground.
A marking
A marking
D marking
C marking
D marking
C marking
B marking
B marking
55mm
screw (A)
45mm
screw (B)
50mm screw (C)
6mm screw (D)
7
*Paste the Jumpking
sticker on top tubing
Insert the tubing into the seat fabric.
Completed
Use mallet to x the metal
peg to the ground.
8
Loading...