INSTRUCTIONS
TAKING
DOWN
your
INSTANT
®
BACKSTOP
2
1
1. Remove all Suction Cups and Tethers. If outdoors,
remove Threaded T-Handle Pegs.
3
If you need
more information about
this product
or any other
JUGS product or service,
please contact
the manufacturer:
In the USA and Canada,
call toll-free:
1-800-547-6843.
For International Orders,
call collect:
0-503-692-1635.
Our fax number is
1-503-691-1100.
Visit our website at
www.jugssports.com.
Se habla español.
© 2008 JUGS Sports
IBSI-0808
INSTANT BACKSTOP
READ THIS NOW
When this INSTANT BACKSTOP® is being
handled it can suddenly and unexpectedly open
to full size. BEFORE REMOVING INSTANT
BACKSTOP
SURE TO READ AND UNDERSTAND THESE
INSTRUCTIONS FOR SETTING UP AND
TAKING DOWN THE INSTANT BACKSTOP®
You must be at least EIGHTEEN YEARS OF
AGE and in good health to set up and take
down this screen. Before removing the INSTANT
BACKSTOP
strap, be sure you have an area of at least 20
feet clear all around you. Do not attempt to unfold
or set up on sloping ground. Failure to heed this
warning could result in SERIOUS INJURY.
For further information, contact manufacturer:
USA & Canada, call toll-free: 1-800-547-6843
International, call collect: 0-503-692-1635
®
FROM CARRYING BAG, BE
®
from the carrying bag or retention
®
2. Release both
attached to the grommets.
Slipcover straps from metal buckles
4
4. Release both Slipcover and Support Pole from
INSTANT BACKSTOP
Straps. Place both Slipcover and Support Pole aside.
®
frame by unfastening Velcro®
3. Remove Crutch Tips from both ends of Support Pole,
then remove ends of Support Pole from both grommets.
5
®
5. Put one side of INSTANT BACKSTOP
the other. This will form a 9-foot circle.
frame on top of
6
6. Stand the INSTANT BACKSTOP
®
up on its side.
SAVE THESE INSTRUCTIONS
7
7. Stand at the opposite end of the JUGS logo. Walk in
front of the screen towards the logo. Put downward
pressure on the middle of the screen. The INSTANT
BACKSTOP
®
will form a figure eight.
8
8. Grab the half of the figure eight without the logo and
fold it on top of the half with the logo. You should now
have a 52-inch circle.
Always remember to place the ELASTIC RETENTION STRAP onto the folded INSTANT BACKSTOP®. Always transport the screen folded and STRAPPED in its CARRYING BAG.
9
9. Keeping control of the circle (if you release too early the
INSTANT BACKSTOP
retention strap.
®
can pop open), put on the
10
10. Take folding Support Pole out of the Slipcover. Fold
the Support Pole. Place your folded and strapped
INSTANT BACKSTOP
with the Support Pole and Slipcover.
®
into the Carrying Bag along
TERMINOLOGY
SETTING
UP
your
INSTANT
®
BACKSTOP
2
1
1. Grasping the edge of the net frame, remove screen from
carrying bag and remove the elastic retention strap.
3
Velcro® Loops
D-Ring
Red Strap
Metal Buckle
Grommet
Crutch Tip
INSTANT BACKSTOP
Velcro® Loops
Slipcover with
Folding Support Pole
Net Frame
Net
Red Strap
D-Ring
Metal Buckle
Grommet
Crutch Tip
®
CRUTCH TIPS
2. Holding the net frame together, toss away from your
body onto a clear, level area.
4
3. The INSTANT BACKSTOP® should now be lying flat on
the ground in a 9-foot circle.
5
SLIP COVER
6
CARRYING BAG
THREADED
T-HANDLE
PEG
TETHER
SUCTION CUP
7
SUPPORT
POLE
ELASTIC
RETENTION STRAP
4. Put folding Support Pole together at its maximum
length of 25 feet. Slide blue Slipcover over
assembled folding Support Pole.
8
8. With two people, one on each side, raise the INSTANT
BACKSTOP® to an upright position. NOTE: The bottom
of the INSTANT BACKSTOP® must be spread to its
maximum width to stand properly.
5. Put one end of the folding Support Pole into one
of the two grommets at the bottom of the INSTANT
BACKSTOP
the metal buckle attached to the grommet. For indoor
use only, please attach Crutch Tip to bottom of Support
Pole once the Support Pole is through the grommet.
®
. Place the strap from the Slipcover into
Frame
9
Support Pole
Slipcover
9. The Support Pole with Slipcover must be on the inside
of the INSTANT BACKSTOP® frame at all points.
6. Attach the Support Pole with Slipcover to the sides
and top of the INSTANT BACKSTOP
Velcro® Straps.
®
with the 15
10
10. With two people, one on each side, pull the Red Straps at
the front of the INSTANT BACKSTOP® to a 45° angle to the
ground. When both Red Straps are tight and the INSTANT
BACKSTOP
to the floor with Suction Cups and Tethers. If outdoors, use
Threaded T-Handle Pegs to secure Red Straps to ground.
®
is upright, attach the end of the Red Straps
7. Place the other end of the Support Pole into the other
grommet. Place the strap from the Slipcover into the
metal buckle attached to the grommet. For indoor use
only, please attach Crutch Tip to bottom of Support
Pole once the Support Pole is through the grommet.
11
11. Secure the D-Rings on both sides of INSTANT
BACKSTOP® using Suction Cups and Tethers. If
outdoors, use Threaded T-Handle Pegs to secure
D-Rings to ground. Your INSTANT BACKSTOP® is
now ready for use.
Always inspect your INSTANT BACKSTOP® before each use. Do not use the INSTANT BACKSTOP
®
if it shows signs of excessive wear or damaged components.