Placethescaleonflatandfirmsurface–thisis
essential for correct measurement.
As soon as “0” appears, the scale is ready for use.
If you put your own bowl on the scale before
switching it on, the weight of the bowl has been
included and the display will show “0”. You may
then put your items onto the bowl for direct weight
reading.
When the scale i
s in use and you want to use your
own bowl for weighing, you can simply place the
bowl on the scale and button to
reset to zero.
The maximum weighing capacity of the scale is 5
KG. The display will show “Err” when the scale is
overloaded.
Auto-Off Function
You may switch off t he scale at any time by
button and hold for 3
seconds.
In order to prolong th
e battery life, the scale will
be switched off automatically when the weight
reading is steady for about 180 seconds.
Weighing
Tare
Tar e
Tare
Quick Guide
2. Insert batteries (see the ‘Replace Battery’
section of this manual).
1. Remove the scale f rom the packaging.
3. Place the scale on flat and firm surface.
4. button to switch
on the scale.
5. When “0” appears on the display, the
scale is ready for use.
Touch Button Operation
Tare Function
The
scaleallowsyoutoweigheachadditional
item as it is added to the scale.
Afte
r weighing the first item on the scale and with
same steps for weighing consecutive items.
Tar e
KG/LB
ON/OFF
the
Tar e
Touch
If
y
ou want to TARE the scale to zero, the
Tar e
To
switch On the scale, the
Tar e
touch
button
for 1 second and release.
touch
button for 1 second and release.
KG/LB Button
The
touch button allows you to choose
KG/LB
Metric
(Kg/g) or lmperial (Lb/oz) as your preferred system of
measurement. However, you may switch between the
two systems at any time without resetting the scale to
zero.
the
item remaining on the scale, the
Tar e
touch
button to reset the scale to zero. You may then add
the second item on the scale and it will show the
weight of the second item only. You may repeat the
Touch button to switch on the scale.
touch the
touching the
To
switch OFF the scale, and hold the
Tar e
button for 3 seconds until the LCD display is switch
touch
-ed OFF
Touch Control Scale
Replace Battery
When “ ” blinks on the display, the
battery must be replaced. The scale requires
2 AAA (1.5V) batteries. The battery compart
-ment is located on the underside of the scale.
To replace the battery, you have to open the
compartment cover and remove the used
battery. Before you replace the new battery
into the compartment, please make sure the
ba
ttery is installed to the correct polarity
(+) / (-). See below:
!!Note: To save our environment, used
battery should be disposed through your
electrical dealer or local resource recycling
collection point.
R602-0020-1187-0001