JTS US-8010D, US-8010, Mh-700D, Mh-700, Mh-800 Instruction Manual
...
Instruction Manual
US-8010D/US-8010/Mh-700D/Mh-700/Mh-800
59506-041-08
US-8010
US-8010D Series
PT-900BD/PT-900B
ank you for choosing the JTS wireless system. In order to obtain the best eciency from the system,
you are recommended to take a few minutes to read this instruction manual carefully.
1. Important Caution
2. Features
3. Specication
3-1 Receiver// US-8010D/ US-8010
3-2 Handheld Transmitter // Mh-700 / Mh-800 / Mh-700D
3-3 Body-pack Transmitter // PT-900B / PT-900BD
3-4 Optional Condenser Microphone
4. Part Identication & Accessories
4-1 Receiver// US-8010D/ US-8010
4-2 Handheld Transmitter // Mh-700 / Mh-800 / Mh-700D
4-3 Body-pack Transmitter // PT-900B / PT-900BD
4-4 Optional Condenser Microphone
4-5 Accessories
5. Preparing Procedures & Basic Operation
5-1 Receiver// US-8010D/ US-8010
5-2 Rack Mounting
5-3 System Operation
5-4 Handheld transmitter // Mh-700 / Mh-800 / Mh-700D
5-5 Body-pack Transmitter // PT-900B / PT-900BD
5-6 Installation of Condenser Microphones
7. Important Notice
1
1
2
2
2
3
3
6
6
6
7
7
11
12
12
13
13
14
15
16
18
19
INDEX
6. Recommendation
WIRELESS MICROPHONE SYSTEM
1
2
1. Important Caution
2. Features
Always makes all connections before plugging the unit into an AC power outlet.•
Do not leave the device in a place neither with high temperature nor high humidity.•
Always do not handle the power cord with wet hands!•
Keep the devices away from re and heat sources.•
Operated in UHF band where there is less RF interference than the VHF band. •
Equipped with a SAW lter can benet to reducing spurious RF content.•
Including balanced XLR output and unbalanced 1/4” output.•
Integrated antenna of the handheld transmier benets less hindrance for performer.•
Built-in noise mute and squelch circuit mode can validly resist extraneous noise. •
Body-pack transmier is available to work together with a lavalier mic. or headset mic.•
Space-saving half-rack housing design.•
3. Specication
3-1 Receiver
3-2 Handheld Transmitter
Model No....................................
Frequency Preparation......
Carrier Frequency Range
Frequency Stability...............
S/N Ratio...................................
T.H.D..................................
Display..............................
Display Contents...................
Controls............................
Audio Output Level............
AF Output Impedance.......
Squelch.............................
Operation Voltage.................
Output Connector................
Dimension(m/m)...............
US-8010D / US-8010
Crystal
600~960 MHz
±10KHz
> 105dB
<0.6%@1KHz
LED
Antenna, RF/AF Status Power On/O,
Audio Level
-12dB
600Ω
Pilot Tone, Noise and Mute
12-18 VDC, 150mA
1 XLR Balanced Socket
1 Unbalanced Ø6.3mm Phone Jack
210mm (W)* 40mm (H)* 171mm (D)
Mode No.............................................
Frequency Preparation..............
Carrier Frequency Range.........
RF Outputs........................................
Stability.................................
Frequency Deviation..................
LED Display......................................
Controls................................
Spurious Emissions.....................
Audio Frequency Response..
Battery..................................
Mh-700 / Mh-800 / Mh-700D
Crystal
600~960 MHz
10mW
±10KHz
±48KHz
Low Baery, Power On/O
Power On/O
<-50 dBC
50~16,000 Hz
UM3, AA 1.5V*2
WIRELESS MICROPHONE SYSTEM
3
4
3-3 Body-pack Transmitter
3-4 Optional Condenser Microphone
Model No..........................................
Frequency Preparation............
Carrier Frequency R ange......
RF Outputs......................................
Stability.................................
Frequency Deviation................
LED Display....................................
Controls.................................
Spurious Emissions...................
Audio Frequency Response
Battery...................................
PT-900 / PT-900BD
Crystal
600~960 MHz
10mW
±10KHz
±48KHz
Power On/O, Low Baery
Power On/O, AF Level
<-50 dBC
40~18,000 Hz
UM3, AA 1.5V*2
Headset Microphone
Model No...............................
Connector..............................
Frequency Response......
Polar Paern..........................
Sensitivity (at 1000Hz)
Impedance.............................
Max. SPL for 1% THD
Dimension(mm)..............
Net Weight............................
CM-235
4P Mini XLR
50~18,000 Hz
Omni-directional
-53±3 dB
1.8kΩ
130dB
155mm(W)
* 134mm(H)
* 157mm(D)
17g (cable excluded)
CX-504
4P Mini XLR
30~18,000 Hz
Cardioid
-68±3 dB
680Ω
130dB
285mm(W)
* 55mm(H)
* 111.3mm(D)
56.3g
Model No...............................
Connector...............................
Option Connector...........
Frequency Response......
Polar Paern..........................
Sensitivity (at 1000Hz)
Impedance.............................
Max. SPL for 1% THD
Dimension(mm)..............
Net Weight............................
CM-214
801C4
(4P Mini XLR)
801C3 (3P Mini XLR)
801CS (3.5 stereo plug)
801CR
60~15,000 Hz
Omni-directional
-60±3 dB
1.8kΩ
130dB
125mm(W)
* 134mm(H)
* 157mm(D)
32.9g
CM-214U
4P Mini XLR
30~18,000 Hz
Cardioid
-68±3 dB
680Ω
130dB
205mm(W)
* 134mm(H)
* 157mm(D)
38.4g
CM-214UL
801C3 (3P Mini XLR)
801C4 (4P Mini XLR)
801CS (3.5 stereo plug)
801CR
100 ~ 18,000Hz
Cardioid
-65±3 dB
1.8kΩ
120dB
125mm(W)
* 134mm(H)
* 157mm(D)
18g (cable excluded)
Model No...............................
Connector..............................
Frequency Response......
Polar Paern..........................
Sensitivity (at 1000Hz)
Impedance.............................
Max. SPL for 1% THD
Dimension(mm)..............
Net Weight............................
CM-501
4P Mini XLR
100~15,000 Hz
Cardioid
-60±3 dB
2.2kΩ
130dB
Ø10.1mm(W)
* 26.4mm(H)
21.5g
CM-201
4P Mini XLR /
60~15,000 Hz
Omni-directional
-60±3 dB
2.2kΩ
130dB
Ø5mm(W)
* 9mm(H)
20.7g
CM-125
4P Mini XLR
50~18,000 Hz
Omni-directional
-53±3 dB
4.4kΩ
130dB
Ø4mm(W)
* 11mm(H)
7g (cable excluded)
Lavaliere Microphone
Loading...