Installation:
GM Series Gooseneck Microphones
(Figure 3)
(Figure 4)
(Figure 2)
(Figure 1)
mixer
Specification:
Accessories:
Windscreen
Model Variations:
■ 1/2” golden plated capsule
■ Cardioid pick up pattern
■ Built in low cut and pad
■ Detachable capsule module design for expansion application
Features:
Type................................
Frequency Response....
Sensitivity......................
Polar Pattern..................
Attenuation Switch.......
Low Frequency Roll-off
Impedance.....................
Max. SPL For 1% T.H.D.
Signal To Noise Ratio...
Power Supply.................
Current consumption....
Output............................
Condenser Mic
20~20,000 Hz
-36±3 dB* (15.8mV) 0dB
=1V /Pa,1kHz
Cardioid
-10dB
80Hz
100Ω
140 dB
78dB
36~52VDC phantom power
≤3mA
XLR-M type(power module)
Length............................
GM-5212T : 468mm
GM-5218T : 620mm
GM-5212T / GM-5218T
1/2” Gooseneck Microphone
1. Equipped with built-in power module, that an external 9V ~ 52V DC source is required to power the unit.
2. Plug connector insert directly into a 3P panel jack on floor stand or conference table. (Figure 2)
3. Adjust gooseneck for aiming the microphone toward the proper sound source. (Figure 3)
4. Slip on windscreen over the microphone head to control breath and popping noise. (Figure 4)
The GM-5212T/GM-5218T bring studio quality sound to PA.
The JS-22MXC capsule module is built on a solid brass with accurate processing. The 1/2” golden plated
diaphragm is manually assembled by JTS craftsman. Precise designed circuit with low cut and pad provides
flat response. This microphone royally reproduces any kinds of vocal and music instruments.
125Hz
250Hz
500Hz
1000Hz
2000Hz
4000Hz
8000Hz
16000Hz
+10
0
-10
20 100 200 500 1k 2k 5k 10k 20kHz