JTS CX500F / MA500 User manual
CX-500F / MA-500 CX-500F / MA-500
}
}
}
125Hz
250Hz
500Hz
1000Hz
2000Hz
4000Hz
8000Hz
16000Hz
+10
0
-10
20 100 200 500 1k 2k 5k 10k 20kHz
Condenser Instrument Microphone / Phantom power Adapter Condenser Instrument Microphone / Phantom power Adapter
CX-500F
Condenser Instrument Microphone / Phantom power Adapter
/
MA-500
The CX-500F is built with full range omni directional capsule with golden plating in and
outside. The at frequency response reproduces all types of utes. Dynamic design of mic
holder can rmly mount CX-500F to utes with dierent sizes while the dual injection
design prevent the ute from scratch. The exible mini gooseneck renders a desirable
miking position while minimizes air stream noises and blasts.
Omni directional pick up pattern
Flat frequency response
Versatile mount clip
Terminated with 4 pin mini XLR for easy wireless application
Phantom power adapter with low cut and pad provided for wired application
Parts ldentication
1
CX-500F Miniature microphone: 1 piece
2
MA-500 Adapter: 1 piece
3
Windscreen (reticular foam cover): 4 pieces
Specication
CX-500F
Type.............................
Frequency Response....
Sensitivity (at 1,000Hz)
Impedance..................
Max.SPL for 1% T.H.D.
Signal-To-Noise Ratio
Output Connector.......
Power Supply.............
Current Consumption
Weight......................
Dimensions(mm)......
Omni-directional Condenser
20~20,000 Hz
-58±3dB*(1.25mV)*0dB=1V/μbar
1.5kΩ
130 dB
68 dB
4P Mini XLR
1-5 VDC
≤0.05mA
8 grams (including cable)
Ø6mm(W)*171mm(H)
MA-500
MIC Input..................
Output......................
Phantom Power........
PAD...........................
Low Cut.....................
Frequency Response
Impedance................
T.H.D.........................
S/N............................
Weight......................
Dimensions(mm)......
4P Mini XLR(Male)
XLR(Male)
12~48V
-10dB
100Hz -6dB
400Hz -4dB
30~20,000Hz
220Ω
<0.045%@1KHz -50dB
>95 dB
40g
Ø20mm*94.5mm(H)
User Manual
Open the rotational button on the xing clip.
1
Place the xing clip into the ute and fasten the rotational button.
2
Place the CX-500F into the xing clip.
3
Adjust the position of CX-500F gooseneck microphone, and it is then ready.
4
1
2
3
4
NI CIM
Input: 4P Mini XLR (Male)
Pin 1: GND
Pin 2: V+
Pin 3,4: Audio signal
Output: XLR (Male)
Pin 1: GND
Pin 2,3: Audio signal
(Phantom Power Supply)
123
4
1 2
3
TUPTUO
MIC IN
V+
PIN2 OUT(+)
PIN3 OUT(−)
Please maintain the temperature in proper status it helps the Subminiature Condenser Instrument Microphone to lengthen its life.
Using the part and adapter made from JTS to ensure the unit quality
and lifetime. Do not attempt to employ non-standard adapters or
connectors as you might damage the unit
59010-091-01
Loading...