JTECH J1707, J1708 User Manual

800.321.6221

©2017 JTECH, an HME Company logo and product names are regist ered trademarks of HM Electronics, Inc. All rights reserved. Part Number: MPGIQ-2

GuestCall® Coaster Pagers

Model Number: J1707, 1708
User Manual Date:

06/28/2017

w/NEO Transmitter

User Manual

2

800.321.6221

GuestCall Paging, Coaster Pagers

Model Number: J1707, J1708

Components

Your GuestCall® paging system is comprised of three key elements:

> The JTECH NEO Desktop Transmitter

> The GuestCall Coaster ® Pagers

> The Coaster Pager Charger

Quick Setup

> Lock the antenna to the connector on the transmitter by placing the antenna on the connector and twisting

left to lock in place.

> Plug the power supply into the transmitter and then into a standard 110-240v outlet. A surge protector is

recommended.

> Compile charger bases and plug charger power supply into charger and then into a standard outlet. Surge

protection is recommended for charging bases.

> Add pagers to charger slots. You will see a BLUE light on each pager. This light indicates the charging status.

o ‘LO’ on the number display: Battery is below 20% charged and SHOULD NOT currently be used.

o Flashing BLUE: Pager is charging and CAN BE available for use.

o Solid BLUE: Pager is fully charged.

o Allow 4 hours for a complete charge of the pagers.

System Use

Distributing a Pager

> Remove a pager from the charger.

> The pager will flash and vibrate to preview what the alert will look like for the guest.

> Hand the pager to the guest, stating that the pager will go off with they have been paged.

Paging a Guest

> To page a guest, enter the 1 to 4-digit pager number into the transmitter and press SEND.

> The pager will alert until it is returned to the charger.

Setup is Complete

If you have any additional questions, please contact us at the addresses below.