
GuestCall® Paging w/ Coaster Pagers
Quick Setup Guide
Components
• JTECH Transmier
Applies to models: IQ Base, NEO, IStaon
• Coaster Pagers
• Coaster Charger
Lock the antenna to the connector on the
transmier by placing the antenna on the
connector and twisng le to lock in place.
Step 1
Plug the power supply into the transmier and
then into a standard 110-240v outlet. A surge
protector is recommended.
Step 2
Compile charger bases and connector wires if
applicable. Plug charger power supply into
charger and then into a standard outlet. Surge
protecon is recommended for charging bases.
Step 3
Add pagers to base. You will see a BLUE light on
each pager. This light indicates the charging
status.
Step 4
• ‘LO’ on the number display: Baery is below 20% charged and SHOULD NOT be used.
• Flashing BLUE: Pager is charging and CAN BE used.
• Solid BLUE: Pager is fully charged.
• Allow 4 hours for a complete charge of the pagers.
Connector Wire
©2017 JTECH, an HME Company logo and product names are registered trademarks of HM Electronics, Inc. All rights reserved. P PM17001-C

Using your GuestCall Paging System
1. Remove a Coaster Pager from the charger.
2. The pager will go through a test page.
3. Hand the pager to the guest, leng them know the pager will go o when they have been paged.
Paging a Guest
1. Enter in the 1 to 4-digit pager number into the transmier and press SEND.
2. The pager will alert unl it is returned to the charger.
1
2
3
v
Addional informaon available at www.jtech.com/support.
1
1
2
©2017 JTECH, an HME Company logo and product names are registered trademarks of HM Electronics, Inc. All rights reserved.