Flux
Installation Instructions
Page 1 of 3
Recommended Tools
Adjustable Table Top Location
Screw Gun
Socket
Wrench
1
/
2
”
Socket
#2 Phillips Head Bit
Level
Center Mount Offset Mount
Hardware Used
#8 x
7
/
”
8
Flat Head Wood Screws
5
/
Flat Washers & Lock Washers
1
”
/
”
16
x 1
4
Hex Head Bolts,
Note: The mounting plate will be shipped fastened to the table top in either center or offset location.
To change the mounting plate/table top location, please follow Step 1. If the mounting plate is
in desired location please proceed to Step 2.
Step 1
Center Mount Offset Mount
• Carefully lay top upside down on a flat smooth surface.
• Align mounting plate to the set of pre-bored holes which
centers the mounting plate to the top. (See below)
• Fasten mounting plate to top using eight (8) #10 x
head wood screws.
Underside of Top
Centered
Mounting Plate
7
/
”
8
flat
Step 1
• Carefully lay top upside down on a flat smooth surface.
• Align mounting plate to the set of pre-bored holes which will
offset the mounting plate to the table top. (See below)
• Fasten mounting plate to top using eight (8) #10 x
head wood screws.
Underside of Top
Offset
Mounting Plate
7
/
”
8
flat
Notice To Installers: Failure to comply with installation instructions will compromise the safety, durability and performance of this product, which may risk injury to the user of this
product and/or diminish the product life cycle. Jasper Group assumes no liability in these instances.
jsifurniture.com
800.457.4511
812.482.3204 O
812.482.1548 F
225 Clay Street / PO Box 231
Jasper, Indiana 47546
Form No. INST-FL003
6/1/18
Flux
Installation Instructions
Page 2 of 3
Step 2
• Place top onto table column aligning the four
mounting holes. Using wrench, firmly secure
top to base using four (4) bolts, flat and lock
washers.
5
/
Flat & Lock Washers
1
”
/
”
16
x 1
4
Hex Head Bolt,
Adjustable Table Top Location
(continued)
Center Mount
Side View
Notice To Installers: Failure to comply with installation instructions will compromise the safety, durability and performance of this product, which may risk injury to the user of this
product and/or diminish the product life cycle. Jasper Group assumes no liability in these instances.
jsifurniture.com
800.457.4511
812.482.3204 O
812.482.1548 F
225 Clay Street / PO Box 231
Jasper, Indiana 47546
Offset Mount
Side View
Form No. INST-FL003
6/1/18
Flux
Installation Instructions
Page 3 of 3
Step 3
Route Electrical Wiring
To adjustable column
To height
control switch
Dongle
Adjustable Table Top Location
(continued)
Attach wire manager
to underside of surface
and route wire accordingly
Plug power cord into
nearest power outlet
Notice To Installers: Failure to comply with installation instructions will compromise the safety, durability and performance of this product, which may risk injury to the user of this
product and/or diminish the product life cycle. Jasper Group assumes no liability in these instances.
jsifurniture.com
800.457.4511
812.482.3204 O
812.482.1548 F
225 Clay Street / PO Box 231
Jasper, Indiana 47546
Form No. INST-FL003
6/1/18
Loading...