JOYTECH PY300DC User Manual

Sliding Gate Operator

User's Manual

PY300DC

Gear-Driven

www.thejoy.com.cn

PY300DC SLIDING GATE OPERATOR

1

OUTLINE

1. Products introduction ……………………………………2

2. Important safety precautions ……………………………2

3. Main technical parameters ……………………………2

4. Mechanical Installation …………………………………3

5. Adjustment ………………………………………………5

6. Wire Connecting …………………………………………6

7. Electrical and control board ………………………………7

8. Porgramming Process ……………………………………8

9. Maintenance ……………………………………………10

10. Trouble Shooting…………………………………………11

11. Packing list ……………………………………………11

PY300DC SLIDING GATE OPERATOR

2

1. Products introduction

please read the instructions carefully before proceeding.
The operator contains Extra battery, transformer, control board and radio control.
In case of power of failure, the operator is powered by a 24Vdc, 1.3Ah, extra battery.
Intelligent charging system supplied.
MCU is supplied to control the gate operator.
Keypad / single button interface.
Photo beam safety beam interface.
User can select Auto-close feature
Soft start & soft stop.
Manual key release design for emergency purposes.
Gate operator has auto-reverse function, and the reverse power can change by user.

2. Important safety information

Carefully read and follow all safety precaution and warnings before attempting to install and use this

automatic gate operator.

Make sure the Power supply(AC220V or AC110V) of operator is suitable for the power supply in
your area.

3. Main technical parameters

Unit Model

PY300DC

Power Supply

220VAC/110VAC

Maximum gate weight

300Kg

Maximum gate width

8m

Motor

24VDC 100W

Output torque

Max. 8N·m

Work duty

S230min

Limit switch

Electronical Limit

Gate Move speed

13m/min

Remote control range≥30 meters

extra remote control

20

Frequency

433.92 MHz

Noise

≤

60 dB

Working temperature

-20ºC ~ +50ºC

Extra Battery

24V 1.3 Ah

PY300DC SLIDING GATE OPERATOR

3

4. Mechanical Installation

The PY300DC will handle gate weighting up to 300Kg and up to 8m if the proper installation procedures
have been followed.
The PY300DC gate operator operates by forcing a drive rack by a drive gear. The entire configuration is
shown in the diagram below.The gate operator must be installed on the inside of the gate.

Sliding gate

Gate operator

Rack

Switch

Input power

Wall

Fig.1

Gate preparation
Be sure the gate is properly installed and slides smoothly before installing the PY300DC sliding gate
operator. The gate must be plumb, level, and move freely.
Conduit
In order to protect the wires, use PVC conduit for low voltage power cable and control wires. Conduit
must be preset into the concrete when it is poured. Wires within the conduit shall be located or protected
so that no damage can result from contact with any rough or sharp part.
Concrete pad
The base unit of the gate operator requires a concrete pad in order to maintain proper stability. The
concrete pad should be approximately 400mm x 250mm x 200mm deep in order to provide for adequate
weight and structure to insure proper stable installation.
Anchors (see Fig.2)
You can use anchor bolts, anchors, washers and nuts. These anchors must be set into the concrete when
it is poured or you can use wedge anchors to fasten the operator.