The TR-8000 is delivered with SW version according to table below which is filled in by either Jotron,
our Distributor, Dealer or Installation company. When SW update is done according to instructions in
Jotron TB 01-2012 (Technical Bulletin), an additional line of information will be filled in to reflect the
latest change. There will be no need for retraining after SW upgrade is performed.
The submeny that shows SW
versions can be found selecting:
(Configuration )
Advanced
System
TR-8000 Operator and Installation Manual 7
3 Introduction
3.1Safety Instructions
This equipment should be installed according to the instructions found in the installation part of
this manual.
The equipment should not be mounted in a way that exposes it for excessive heat from the sun
or other sources.
The equipment should not be mounted in a flammable environment. The equipment should not be mounted in a way that exposes it to direct rain or water.
CAUTION!
This equipment contains CMOS integrated circuits. Observe handling precautions to avoid static
discharges which may damage these devices.
Do not open equipment. Only qualified personell should service the equipment.
3.2 Compass Safe Distance
Transponder unit:
Standard Compass: 95cm
Steering compass: 65cm
Display unit:
Standard Compass: 30cm
Steering compass : 14cm
3.3 Copyright Notice
This manual, as well as the software described in it, is furnished under license and may be used or
copied only in accordance with the terms of such license. The content of this manual is furnished for
informational use only, is subject to change without notice, and should not be constructed as a
commitment by Jotron AS. Except as permitted by such license, no part of this publication may be
reproduced, stored in a retrieval system, or transmitted, in any form or by any means, electronic,
mechanical, recording, or otherwise, without the prior written permission by Jotron AS.
Please remember that existing artwork or images that you want to include in your project may be
protected under copyright law. The unauthorized incorporation of such material into your new work
could be a violation of the rights of the copyright owner. Please be sure to obtain any permission
required from the copyright owner.
3.4 Disclaimer Notice
The information in this book has been carefully checked and is believed to be accurate.
However, no responsibility is assumed for inaccuracies.
Jotron AS reserves the right to make changes without further notice to any products or modules
described herein to improve reliability, function or design.
Jotron AS does not assume any liability arising out of the application or use of the described product
TR-8000 Operator and Installation Manual 8
3.5 Disposal Instructions
The TR-8000 Transponder and Display shall be disposed according to local regulations regarding
Electronic Waste Recycling in the country the equipment is taken ashore.
At time of writing this manual (2012), there are some common regulations which allies:
Europe:
Directive 2002/96/EC (WEEE) Waste Electrical and Equipment Directive
Equipment is labeled with this symbol:
USA:
Most states have implemented some kind of recycling act, but there is not yet a federal law
about this issue.
Elsewhere:
Follow local regulations regarding disposal of electronic equipment
3.6 Software and Hardware revisions
See chapter 1 & 2
3.7 Ingress protection
Transponder unit:
IP56 IPx6 IEC 60945, Exposed
Display unit:
IP54 IEC 60945, Protected
TR-8000 Operator and Installation Manual 9
4 Operation general introduction
Thank you for purchasing this Jotron AIS Class A transceiver.
The Jotron TR-8000 has been developed to offer you the highest level of performance and durability
and we hope that it will provide many years of reliable service. This product has been designed to meet
the highest possible quality standards and should you encounter any problems with this product, please
contact your local dealer who will be pleased to offer any assistance.
4.1 About AIS in general
The system is based on the IMO regulation for AIS using Self Organized Time Division Multiple Access
(SOTDMA) technology based on a VHF Data Link (VDL).
The system operates in the following modes:
o Autonomous (continuous operation in all areas)
o Assigned (data transmission interval remotely controlled by authority in traffic monitoring
service)
o Polled (in response to interrogation from a ship or authority)
o Silent (listening only, use with caution)
The system is synchronized with GPS time (UTC) to avoid conflict among multiple users. If GPS data
is not available, the system is self synchronized using the VDL.
The VHF channels 2087 and 2088 are the main AIS channels in addition to local AIS frequencies.
AIS transponders onboard ships exchange various data as specified by IMO and ITU on either
frequency set up by :
o The frequency management telecommand (DSC)
o Special AIS messages sent from a AIS Base station.
o Manual input of special region
The normal transmit power is 12.5W, but under certain conditions, as during tanker loading
(according to ISGOTT regulation), or the use of regional settings, a low power option (1W) is
automatically selected.
TR-8000 Operator and Installation Manual 10
5 Equipment List
Stock No.
Name
Type
Qty.
85300
TR-8000 Transponder Unit
1 85400
TR-8000 Display Unit
1 85041
Mounting bracket, Display unit
1
85042
Locking ring, mounting bracket
2
85720
Curled knob, mounting bracket
2 86853
GPS Antenna, std
SANAV SA-200
1
86854
GPS Antenna stainless stand
1 86145
Cable, 5m Patch RJ45 waterproof
1 86848
Operator and Installation Manual
1 86581
Power cable, TR-8000 Display unit
1
Plug Kit consisting of:
TNC connector for RG214 cable
BNC Connector “ RG214 cable
Power connector
……
Stock No.
Name
Type
82484
VHF Antenna
Procom CXL 2-1LW/h
84401
GPS/VHF combined antenna
AC Marine AIS/GPS-B
81768
Jotron Signal Splitter
86870
Pilot cable for TR-8000 display
Jotron
80665
AC/DC Power 100-240 VAC/ 24V DC
Jotron
92375
240V AC cable, Europe (for 80665)
Jotron
97521
AC Power cable, UK. (for 80665)
Jotron
81986
AC Power cable, USA (for 80665)
Jotron
5.1 Standard Supply
85500 TR-8000 AIS Class A :
5.2 Optional Supply
TR-8000 Operator and Installation Manual 11
6 TR-8000 Description
The Tron AIS TR-8000 consists of two separate units interconnected by Ethernet. The Transponder is the
main unit, handling the basic AIS functionality, including sensors and RF functions, while the Display unit
is used for setup and display of the AIS data.
TR-8000 Operator and Installation Manual 12
Loading...
+ 26 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.