Joovy Caboose Too Ultralight 0087X, Caboose Too Ultralight User Manual

Joovy • 2919 Canton Street • Dallas, TX 75226 • [phone] • Fax [phone] • Email: [e-mail] • Website: www.joovy.com

©joovy 2013 • Document Version 110613

Caboose Too Ultralight

0087X

EN

Caboose Too Ultralight Instruction Manual

EN

Please read this instruction manual completely before using this stroller. Keep these instructions for future reference.

• Failure to follow these instructions could result in serious injury or death.

• NEVER leave child unattended.

• Avoid serious injury from falling or sliding out.

• Always use restraint system and ensure that all children are positioned according to these instructions.

• Keep all small parts out of reach of children while assembling the stroller.

• Be certain that the stroller is fully opened, all of the locking devices are engaged, and the parking device is engaged before allowing children
near the stroller or any use.

• The parking device should always be engaged during the loading and unloading of children.

• The front seat is not suitable for a child under 3 months.

• The front seat is intended for a child up to a maximum weight of 45 lbs.

• The rear forward facing seat is not suitable for a child under 6 months.

• The rear forward facing seat is intended for a child up to a maximum weight of 45 lbs.

• The rear stand-on platform and the rear bench seat are designed for a child that is at least 2-1/2 years old, but LESS than 44 inches tall and
45 lbs.

• Use of the stroller with children totaling more than 90 lbs. will cause excessive wear and stress on the stroller and may cause a hazardous
unstable condition.

• Never use this stroller to carry more than 2 children at the same time.

• Never allow a child to step on the footrest to get into or out of the stroller.

• Do not use the stroller on stairways or escalators.

• DonotaddanyattachmentnotspecicallyrecommendedbyJoovy.

• Any load attached to the handle affects the stability of the stroller. Hanging purses, shopping bags, parcels, changing bags or other accessory
items from handle bars or any other parts of the stroller may change the balance of the stroller and cause a hazardous unstable condition.

• The maximum weight that can be carried in the storage basket is 5 lbs. Excessive weight may result in a hazardous unstable condition.

• When installing an infant car seat onto the stroller, ALWAYS use the restraining strap to secure the infant car seat in place.

• The maximum weight that can be carried in each cup holder or the tray is 2 lbs.

• This product is not suitable for running or skating.

• Never allow your stroller to be used as a toy.

• Discard all packaging materials properly. Do not allow children to play with them.

• Check your stroller for loose rivets, snaps, worn parts, and torn material or stitching on a regular basis.

• Discontinue use of the stroller should it malfunction or become damaged.

Please do not return this product to the store

If you experience any difculty with the assembly or use of this product, or if you have a question regarding these instructions, please

contact our Customer Service Department at [phone] between the hours of 8:30 am and 5:00 pm Central Time.

Please note: Styles and colors may vary.

1 Unpacking the Product

• Remove everything from the box and identify the parts using Figure 1.1. (not to scale)

A: stroller, B: caboose too rear seat C: canopy, D: rear axle, E: two rear wheels, F: two front wheels sets, G: tray, H: plastic cap, I: two

small washers, J: four large washers, K: two spring washers, L: two snap pins, M: two hub caps N: infant car seat adapter (OPTIONAL),
O: parent organizer (OPTIONAL), rain cover (OPTIONAL and not shown) and documents (not shown).

NOTE: The rear axle is attached to the rear frame. Detach the axle from the frame and remove the yellow foam padding. Extra parts may

be included.

• Discard all packaging materials properly including plastic coverings.

• DO NOT allow children to play with any packaging materials.

2 Unfolding

• Keep children away from stroller while unfolding.

• Release the folding lock located on the right side by lifting the lever off of the catch. See Figure 2.1.

• Lift up on the handle of the stroller until the frame snaps into its open locked position.

CAUTION: While unfolding the stroller, be careful to keep your ngers from being pinched by moving parts.
NOTE: Remove packing foam from rear frame assembly to ensure stroller locks in the open position.

• Lock the safety latch. See Figure 2.2.

• Ensure that the safety latch is secured before ANY use of the stroller.

!

WARNING

!

WARNING

Adult assembly is required for this product. No tools required.

This package contains small parts. Keep all small parts away from children during assembly.

!

WARNING

ALWAYS secure the safety latch on the side of the stroller when it is in the unfolded use position. This will prevent collapse of the stroller

should the handle trigger locks be accidentally opened.

Possible pinching hazard - Be careful when unfolding the stroller.

EN

EN

6 Installing and Operating the Canopy

• Position the canopy with the sun visor forward.

• Insert the canopy attachments into the frame mounts on BOTH sides. Ensure they snap into place. See Figure 6.1.

• The canopy can be adjusted forward and back, and locked open using the canopy locks on BOTH sides. See Figures 6.2 and 6.3.

• To close the canopy, unlock the sides, then collapse. See Figure 6.4.

• To remove the canopy, press the lock buttons on BOTH sides of the canopy and pull up. See Figure 6.5.

3 Installing Rear Wheels

• Turn stroller upside down.

• Insert the rear axle through both holes under the stand-on platform. See Figure 3.1.

• Install the parts in the following order. See Figure 3.2.
Small washer
Wheel (brake cluster facing inward)
Large washer
Spring washer
Large washer
Push snap pin through the hole in the axle until it snaps in place.

• Push the axle as far as it will go toward the opposite side of the stroller.

• Next turn the stroller onto its side, with the already assembled wheel toward the oor. Place the axle onto the center of the solid surface of

the red plastic cap so that the axle is pushing upwards for easier installation. See Figure 3.3.

• Repeat the installation steps for the other wheel.

• Push the hubcaps on until they snap in place. See Figure 3.4.

5 Front Wheel Locks

The front wheels can be set to swivel or lock.

• To lock the front wheels, rotate each wheel set so that it points forward.

• Pull up on the red locking lever to engage the swivel lock. See Figure 5.1.

• To unlock the wheels (swivel mode) push down on the lever.

4 Installing Front Wheels

• Place the front wheel sets onto the front wheel posts until they click in place. See Figure 4.1.

• Pull on the wheel sets to ensure they are installed properly.

7 Attaching/Detaching the Front Tray

• To attach the front tray, slide the tray onto BOTH red mounts until they snap in place. See Figure 7.1.

• To remove tray, press the lock buttons on BOTH mounts and pull forward. See Figure 7.2.

!

WARNING

Possible pinching hazard - Be careful when closing and opening the side hinges so as not to pinchyourngers.

!

WARNING

The child tray is not a restraint device. Always secure your child with the restraint system. Never lift the stroller by the child tray. Use caution

when attaching the child tray when there is a child seated in the stroller.

8 Rear Wheel Brakes

• Always engage rear brakes before placing child in or removing a child from the stroller.

• To engage the brakes, push down on either of the red brake levers until the brake snaps in place. See Figure 8.1.

• Check that BOTH wheel brakes are properly engaged.

• To release the brakes, lift up on the brake lever. See Figure 8.2.

!

WARNING

Always engage the parking brake when the stroller is not being pushed so that it will not roll away. Never leave stroller unattended, especially

on a hill or incline, as the stroller may tip over or slide.