Joovy 40X, 41X User Manual

Caboose Stand-On Tandem
Instruction Manual
40X & 41X Series
Patent No. 5,622,375
Joovy • 2919 Canton Street • Dallas, TX 75226 • (877) 456-5049 • Fax: (214) 761-1774
E-mail: customerservice@joovy.com • Website: www.joovy.com
Please read this instruction manual completely before using
! WARNINGS
this stroller. Keep these instructions for future reference.
• Failure to follow these instructions could result in serious injury or death.
• Never leave child unattended.
• Avoid serious injury from falling or sliding out.
• Always use safety belts and ensure that all children are positioned according to these instructions.
• Keep all small parts out of the reach of children while assembling the stroller.
• Be certain that the stroller is fully opened, the safety latch is in position, and the wheel brakes are on before allowing children near the stroller.
• The maximum weight of the child that can be seated in the front seat is 45 lbs.
• The rear stand-on platform and the rear bench seat are designed for a child that is at least 2-1/2 years old but LESS than 44 inches tall and less than 45 lbs.
• Use of the stroller with two children weighing more than 45 pounds each, or children totaling more than 90 pounds, will cause excessive wear and stress on the stroller and may cause a hazardous unstable condition.
• Never use this stroller to carry more than 2 children at the same time.
• Never allow a child to step on the footrest to get into or out of the stroller.
• Do not use the stroller on stairways or escalators.
• Hanging purses, shopping bags, parcels, diaper bags or other accessory items from the handle bars or any other parts of the stroller may change the balance of the stroller and cause a hazardous unstable condition.
• The maximum weight that can be carried in the storage basket is 5 pounds. Excessive weight may result in a hazardous unstable condition.
• The total weight of contents in the seatback mesh pockets should be less than 2 pounds. Excess weight may cause a hazardous unstable condition.
• When installing an infant carrier onto the stroller, ALWAYS use the restraining strap to secure the carrier in place.
• Never allow your stroller to be used as a toy.
• Discard all packaging materials properly. Do not allow children to play with them.
• Check your stroller for loose rivets, snaps, worn parts, and torn material or stitching on a regular basis.
• Discontinue use of the stroller should it malfunction or become damaged.
Please do not return this product to the store
If you experience any difculty with the assembly or use of this product, or if you
have a question regarding these instructions, please contact our Customer Service
Department at (877) 456-5049 between the hours of 8:30 am and 5:00 pm Central Time.
Please note: Styles and colors may vary.
Page 1 Page 2
Caboose Stand-On Tandem Instruction Manual
Assembling and Using your Stroller
To ensure safe operation of your stroller, please follow these instructions carefully.
Unpacking the Product
• Carefully remove stroller and all parts from the box and plastic bag.
• Identify the parts (stroller, front wheels (2), rear wheels (2), canopy, tray, car seat carrier
support, rear axle, washers (4), snap pins (2), hub caps (2) and documents) with the pictures in Figures 1a and 1b.
NOTE: The rear axle is attached with red tie wraps to the rear frame tube. Please carefully
detach the axle from the frame and remove the yellow foam from the ends of the axle for installation. Also, extra washers and snap pins may be included.
• Discard all packaging materials properly.
• Remove the plastic coverings from all foam handles and any other areas of the product and
discard also.
• DO NOT allow children to play with any packaging materials.
Figure 1a
Figure 1b
CAUTION
Adult assembly is required for this product. This package contains small
parts. Keep all small parts away from children during assembly.
No Tools Required.
Caboose Stand-On Tandem Instruction Manual
Unfolding the Stroller
• Keep children away from stroller while unfolding.
• Position the stroller with the handle bar closest to you.
• Release the locking latch located on the right side by lifting the lever off of the
extended rivet. See Figure 2.
• Lift up slightly on the handle of the stroller. Then place one foot onto the rear
platform and pull up and back on the handle until both side frame bars snap into their locking positions in the frame.
CAUTION: While unfolding the stroller be careful to keep your ngers from being
pinched by moving parts.
• Lock the safety latch on the lower left side of the stroller by pushing the lever
down over the extended rivet. See Figure 3.
• Ensure that the stroller is completely opened and the safety latch is secured
before ANY use of the stroller.
Figure 2 Figure 3
WARNING
ALWAYS secure the safety latch on the side of the stroller when it is in the
unfolded use position. This will prevent collapse of the stroller should the
handle trigger locks be accidentally opened.
Installing the Rear Wheels
• Turn stroller upside down, on a clean surface, so that it rests on the handlebar.
• Insert one end of the rear wheel axle through a rear axle hole in the plastic bracket
under the stand-on platform.
• Push the axle across and into the axle hole on the other side of the stroller. Note,
you may need to guide the axle into this hole. Slide washers over each end of the axle. See Figure 4.
• Place one rear wheel over one end of the axle. See Figure 5. NOTE: The brake
teeth on the wheel should be facing inward toward the red brake lever AND the arrow shapes on the tire tread should point toward the handlebar.
• Slide an additional washer over the end of the axle.
• Take one snap pin and insert the straight leg into the small hole in the axle. Push it
rmly into this hole until the round portion of the other leg snaps completely around
the outside of the axle. See Figure 6.
Page 3 Page 4
Caboose Stand-On Tandem Instruction Manual
• Push the axle as far as it will go toward the opposite side of the stoller, then repeat
the installation steps for the other wheel.
• Install a hubcap onto each wheel by aligning the 5 tabs on the hubcap with the 5
slots in the wheel, and then pushing it into place. Ensure that ALL 5 snaps have engaged securely and the hubcap cannot be pulled off. See Figure 7.
Figure 4 Figure 5
Figure 6 Figure 7
Installing the Front Wheels
• Take one of the double wheel sets and
locate the small hole in the rotating bracket that is inside the red lever.
• Push the front axle into this hole and
keep pushing the wheel set onto this axle until you hear an audible click. See Figure 8.
• Pull downward on the wheel set to
ensure that it has locked into position on the axle.
• Repeat this same procedure for the
other wheel set.
• When assembled properly, both wheel
sets should rotate and roll smoothly.
Caboose Stand-On Tandem Instruction Manual
Figure 8
Front Wheel Locks
The front wheels can be either in swivel mode or locked mode.
• To put the front wheels in their locked
mode, rst rotate each wheel set so
that the wheels are pointed straight ahead.
• Pull up on the lever to engage the
small tab on the lever with the slot in the plastic frame sleeve. The lever can be either facing forward or rearward to lock the wheels. See Figure 9.
• To unlock the wheels and put them
into swivel mode, push down on the lever to disengage the tab from the slot.
Figure 9
Installing and Operating the Canopy
• To attach the canopy, position the canopy on the stroller with the thick padded
edge toward the front of the stroller.
• Line up the male ttings on the canopy with the female ttings near the center of
the stroller and push downward until the ttings snap into place. See Figure 10.
Pull upward on the canopy sides to be sure both are snapped securely in place.
• To open the canopy, pull forward on the front edge of the canopy while holding
the back edge in place. Once the canopy is fully opened, push down on BOTH side hinges to lock it in the open position.
• The canopy will ratchet forward or backward to help block the sun. Pull forward
on the front of the canopy frame tube to rotate it forward. Pull backward on the rear frame tube to rotate it backward. See Figure 11.
• To close the canopy, unlock the side hinges and pull the front edge toward the
rear of the stroller until folded. See Figure 12.
• To remove the canopy, press the lock button on the side of each of the male
ttings while pulling upward on the canopy frame. See Figure 13.
Figure 10
Page 5 Page 6
Figure 11
Caboose Stand-On Tandem Instruction Manual
Loading...
+ 14 hidden pages