ASSEMBLY INSTRUCTIONS FOR YOUR
MEURICE RECTANGULAR CHANDELIER
IMPORTANT SAFETY INSTRUCTIONS:
*These instructions are provided for your safety. It is very important that
they are read completely before beginning the installation of your fi xture.
*Turn off power at switch before replacing bulbs.
OUTLET BOX
(A)
(C)
(L)
(M)
(I)
(K)
15. Install forty two 25W MAX. G16.5, Candelabra base bulbs into sockets.
16. Reconnect main electrical supply from the fuse box/circuit breaker and test the fi xture.
(G)
(J)
(J)
(J)
(J)
(B)
(H)
*If any special control devices are used with this fi xture, follow the
instructions carefully to assure full compliance with N.E.C. requirements.
If there are any questions, contact a qualifi ed electrical contractor.
(F)
*WE STRONGLY RECOMMEND INSTALLATION BY A LICENSED
ELECTRICIAN.
(D)
(E)
**SHUT OFF ELECTRICAL SUPPLY AT CIRCUIT BREAKER**
1. Remove all parts carefully from the carton. Do not throw away any parts.
2. Remove mounting plate (A) from canopy (D) by removing canopy
screws (E). Set canopy screws (E) aside.
3. Lift the mounting plate (A) to the ceiling outlet box. Once aligned, use a
pencil to mark the locations of mounting holes (F) on the outside edges
of the mounting plate.
4. Set the mounting plate aside and drill small holes at the marked locations.
Holes should be sized so anchors (L) fi t securely inside. Push the anchors
into the holes.
5. Attach mounting plate (A) to ceiling outlet box using screws (B). Thread
screws (M) through holes (F) and into wall anchors (A) to secure the
mounting plate to the ceiling.
6. Measure desired drop for fi xture to hang and add/remove extension tubes
(J) as needed. Guide wiring through extension tubes before threading
tubes together. **TO ADD/REMOVE EXTENSIONS: (Un)Thread the
threaded nipple of one extension into/out of the threaded opening of the
next extension. Make sure electrical cord is pulled tight when threading
extensions together to prevent damage to the wiring.**
7. Thread the bottom extension tube (J) onto threaded tube (K).
8. Guide wiring from top extension (J) through quick link (H) and hang
straight (G), exiting canopy (D). Lift canopy (D) to ceiling outlet box.
9. Make proper electrical connections described in steps 10-12.
A LICENSED ELECTRICIAN IS RECOMMENDED.
10. Attach ground wire from fi xture (green or silver in color) to
ground wire from outlet box. Fasten wires together with wire
nut (C) and tightly wrap connection with electrical tape.
11. Attach hot wire from fi xture (black in color or smooth side
of wire) to hot wire from outlet box. Fasten wires together
with wire nut (C) and wrap connection with electrical tape.
12. Attach neutral wire from fi xture (white in color or ribbed
side of wire) to neutral wire from outlet box. Fasten wires
together with wire nut (C) and tightly wrap connection with
electrical tape.
13. Carefully push wire connections back into ceiling outlet box.
14. Place canopy (D) over mounting plate (A). Thread canopy
screws (E) into holes in canopy (D), and mounting plate (A)
to secure fi xture to ceiling.
ASSEMBLY INSTRUCTIONS
***To clean, use soft cloth only. Do not use any chemical or abrasive cleaners.***
687
Loading...