Johnson Health Tech PHOENIX User Manual

CXP
2
IMPORTANT PRECAUTIONS
SAVE THESE INSTRUCTIONS
• When using Matrix Cycles, basic precautions should always be followed, including the following: Read all instructions before using this equipment. It is the responsibility of the owner to ensure that all users of this equipment are adequately informed of all warnings and precautions.
• This equipment is intended for commercial use. To ensure your safety and protect the equipment, read all instructions before operating.
WARNING!
TO REDUCE THE RISK OF BURNS, FIRE, ELECTRICAL SHOCK OR INJURY TO PERSONS:
ENGLISH
• Use this indoor cycle for its intended purpose as described in this manual. Do not use attachments that have not been recommended by the manufacturer.
• Never operate the indoor cycle if it is not working properly, or if it has been damaged. Contact Customer Tech Support or the authorized dealers for examination and repair.
• Do not use the indoor cycle without proper footwear. NEVER operate the indoor cycle with bare feet.
• Do not wear any clothing that might catch on any moving parts of this indoor cycle.
• Keep hands and feet clear at all times from moving parts to avoid injury. Never turn the pedal cranks by hand.
• Do not dismount the indoor cycle until the pedals are at a complete STOP.
• Do not insert any object, hands or feet into any openings, or expose hands, arms or feet to the drive mechanism or other potentially moving part of the indoor cycle.
• Do not use any equipment that is damaged or has worn or broken parts. Use only replacement parts supplied by Customer Tech Support or the authorized dealers.
• Do not operate where aerosol (spray) products are being used or when oxygen is being administered.
• Close supervision is necessary when used near children.
• This equipment is not intended for use by persons with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the equipment by a person responsible for their safety.
• Ensure that adjustment levers (seat and handlebar fore-and-aft) are properly secured and do not interfere with range of motion during exercise.
• When adjusting the seat and handlebar height, hold the seat or handlebar with one hand, while lifting and then locking the lever. Ensure clamp is fully engaged prior to use.
• Incorrect or excessive exercise may result in serious injury or death. If you experience any kind of pain, including but not limited to chest pains, nausea, dizziness, or shortness of breath, stop exercising immediately and consult your physician before continuing.
• Do not jump on the unit.
• At no time should more than one person be on unit while in operation.
• This unit should not be used by persons weighing
more than specied in the PRODUCT SPECIFICATIONS SECTION. Failure to comply will void the warranty.
• Do not use other attachments that are not recommended by the manufacturer. Attachments may cause injury.
• To clean, wipe surfaces down with soap and slightly damp cloth only; never use solvents. (See MAINTENANCE)
• At NO time should pets or children under the age of 14 be closer to the unit than 10 feet.
• At NO time should children under the age of 14 use the unit.
• Children over the age of 14 should not use the unit without adult supervision.
• Heart rate monitoring systems may be inaccurate.
• After exercising, push down on the brake lever to slow
the ywheel down and decrease the potential for injury.
• The indoor cycle does not have a independently
moving ywheel; the pedals will continue to move together with the ywheel until the ywheel stops.
• Use the stationary training equipment in a supervised environment.
CAUTION!
CONSULT A PHYSICIAN BEFORE USING THIS EQUIPMENT. READ OWNER’S MANUAL BEFORE USE.
• It is essential that this equipment is used only indoors, in a climate controlled room. If this equipment has been exposed to colder temperatures or high moisture
climates, it is strongly recommended that the equipment is warmed up to room temperature and allowed time to dry out before rst time use.
3
ENGLISH
ASSEMBLY
UNPACKING
Unpack the equipment where you will be using it. Place the carton
on a level at surface. It is recommended that you place a protective covering on your oor. Never open box when it is on its side.
IMPORTANT NOTES
During each assembly step, ensure that ALL nuts and bolts are in place and partially threaded.
Several parts have been pre-lubricated to aid in assembly
and usage. Please do not wipe this off. If you have diculty,
a light application of lithium grease is recommended.
WARNING!
There are several areas during the assembly process that special attention must be paid. It is very important to follow the assembly instructions correctly and to make sure all parts
are rmly tightened. If the assembly instructions are not
followed correctly, the equipment could have parts that are not tightened and will seem loose and may cause irritating noises. To prevent damage to the equipment, the assembly instructions must be reviewed and corrective actions should be taken.
TOOLS REQUIRED:
F 3 mm Allen Wrench
F 5 mm Allen Wrench
F 10 mm Allen Wrench
F Flat Wrench (15mm/17mm 325L)
F Phillips Screwdriver
PARTS INCLUDED:
F 1 Main Frame
F 1 Front Stabilizer Tube
F 1 Rear Stabilizer Tube
F 1 Handlebar Set
F 1 Transport Handle
F 1 Bicycle Saddle
F 2 Pedals
F 1 Console
F 1 Hardware Kit
WARNING
SEAT AND HANDLEBARS: HOLD WITH ONE HAND WHILE ADJUSTING HEIGHT. ENSURE CLAMP IS FULLY ENGAGED PRIOR TO USE.
USE THE STATIONARY TRAINING EQUIPMENT IN A SUPERVISED ENVIRONMENT UNDER THE DIRECT SUPERVISION OF A TRAINED INSTRUCTOR.
SPINNING PEDALS CAN CAUSE INJURY.
THIS EXERCISE BICYCLE DOES NOT HAVE A
FREEWHEEL AND PEDAL SPEED MUST BE
REDUCED IN A CONTROLLED MANNER.
CAUTION
KEEP CHILDREN UNDER THE AGE OF 14 AWAY FROM EXERCISE EQUIPMENT.
ALL WARNINGS AND INSTRUCTIONS SHOULD BE READ AND PROPER INSTRUCTION OBTAINED PRIOR TO USE. USE THIS EQUIPMENT FOR ITS INTENDED PURPOSE ONLY. CONSULT A PHYSICIAN BEFORE USING THIS EQUIPMENT.
SET UP AND OPERATE THE STATIONARY EXERCISE
BICYCLE ON A SOLID LEVEL SURFACE. CARE
SHOULD BE TAKEN IN MOUNTING AND
DISMOUNTING THE STATIONARY EXERCISE
BICYCLE. BEFORE DISMOUNTING,
BRING THE PEDALS TO A
COMPLETE STOP.
NEED HELP?
If you have questions or if there are any missing parts, contact Customer Tech Support. Contact information is located on the information card.
SERIAL NUMBER
MODEL: CXP MATRIX TARGET TRAINING CYCLE
* Use the information above when calling for service.
4
TENSION CONTROL & EMERGENCY BRAKE LEVER
SADDLE
HANDLEBARS
ENGLISH
CONSOLE
HORIZONTAL SADDLE ADJUSTMENT LEVER
SADDLE HEIGHT ADJUSTMENT LEVER
MAIN FRAME
SERVICE PANEL
FLYWHEEL
TRANSPORT HANDLE
WATER BOTTLE HOLDER
HORIZONTAL HANDLEBAR
ADJUSTMENT LEVER
HANDLEBAR HEIGHT
ADJUSTMENT LEVER
PEDALS
CRANK
TRANSPORT WHEELS
REAR STABILIZER TUBE
FRONT STABILIZER TUBE
LEVELERS
5
A
B
C
B
E
D
F
ENGLISH
Red Hardware Pack
1 2
Description Qty
A
Bolt (M12x25L)
B
Flat Washer
C
Bolt (M12x70L)
2
4
2
Black or Yellow Hardware Pack
Description Qty
D
Stopper
E
Screw (M8x20L)
F
Screw (M4x6L)
1 1
2
Slide handlebars onto frame before attaching (D), (E) and
then (F)
Torque Value
AC78 Nm / 58 ft-lb
78 Nm / 58 ft-lb
Torque Value
E 20 Nm / 14 ft-lb
6
Loading...
+ 13 hidden pages