John Guest JGSTAT1 Instruction Manual
Instruction Manual
230v Dial Thermostat
Instruction Manual JGSTAT1
Instruction Manual
230v Dial Thermostat
Fixing screws
Instruction manual:
• Box contents
• Introduction
• Product compliance
• Safety information
• Mounting position and installation
•
System grouping and communication
• User interface
• LED indication
Contents
Icons used in this manual:
Safety
Important info
Your benefit
For latest PDF Instruction Manual please
go to speedfitUFH.co.uk
Box contents:
02
JGSTAT1 Instruction Manual
We hope you enjoy this product...
Introduction.
Thank you for purchasing the
Speedfit Aura Dial Thermostat JGSTAT1. This is
a 230v Dial Thermostat which offers simple
temperature control of your heating system.
Speedfit recommends that you use your
JGSTAT1 with the Aura JGWC Wiring Centre
and JGSTAT2 Digital Room Thermostat. The
JGSTAT2 can be used as a group control
thermostat to control groups of STAT1s.
Please see pages 6 and 7.
Safety Information. Use in
accordance with the regulations. The
Aura JGSTAT1 is to be used for
room control of hot water heating
systems inside buildings.
Installation
.
This product must be
fitted by a competent person, and
installation must comply with the
guidance, standards and regulations
applicable to the location where the
product is installed. Failure to comply
with the requirements of the relevant
guidance, standards and regulations
could lead to injury, death or
prosecution.
Always isolate the AC mains supply
before installing or working on any
components that require 230v AC
50Hz supply.
Product Compliance. This
product is CE compliant and meets
the following Directives:
EMC 2014/30/EU, LVD 2014/35/EU
and RoHS 2011/65/EU.
Declaration of conformity available
at saluslegal.com
Product Compliance & Safety Information
03
speedfitUFH.co.uk
Product Compliance & Safety Information
These instructions are applicable to the
Speedfit Aura model stated on the front cover
of this Instruction Manual only.
Sources of danger. The thermostat
must be disconnected from mains
supply before removing the cover.
Emergency. Switch off the voltage to
the individual thermostat wiring centre
or complete system.
230v AC
Installer parameter settings.
The Aura JGSTAT1 is equipped with
Installer Parameters (see page 13).
For the installer. Please enter any
parameter changes in the Installer
Notes section.
04
JGSTAT1 Instruction Manual
130cm
Mounting position and installation. To ensure trouble free operation and efficient
control, the unit is best positioned in a draft free area and at 130cm from the floor.
Do not position the thermostat near any heat source, behind curtains, direct sunlight
or an area of high humidity.
Installation - Thermostat Mounting
Not to be positioned on an exterior wall.
05
speedfitUFH.co.uk
INSTALLATION
Power and Switching Cable - used to power
thermostats and drive output.
Grouping and Communication cable.
While the thermostats can function as standalone, installing
this optional inexpensive communication cable allows the
thermostats to communicate with the Aura JGSTAT2
configured as a group control thermostat and used with the
Aura JGWC Wiring Centre (both sold separately).
The JGSTAT1 will follow instructions from the JGSTAT2 bringing
central control of features such as Time Control, Holiday and
Party functions as well as Frost Control. The JGSTAT1 can
leave or re-enter group control at the slide of a switch.
JGSTAT2 Group Control
Thermostat (sold separately).
System Overview - Grouping and Communication
06
JGSTAT1 Instruction Manual
The maximum number of groups per JGWC Wiring Centre is two. The group selection
communication cable must correspond to the group terminals on the JGWC. Please
refer to the JGWC Wiring Centre Instruction Manual.
Aura JGWC Wiring Centre
System Overview - Grouping and Communication
07
speedfitUFH.co.uk
INSTALLATION
Group 1 – For example, downstairs Group 2 – For example, upstairs
Carefully remove the front housing.
Installation - Thermostat Mounting
1
2
3
60mm
Wall Mounting. For wall mounting, mark and mount
the rear case to the wall. The JGSTAT1 is suitable for
wall boxes with a centre hole distance of:
08
JGSTAT1 Instruction Manual
Loading...