JMC SC510N4 SDI User Manual

Page 1
JMC Systems Engineering AB www.jmc.se +46-8-82 82 70 info@jmc.se
User Guide
Model – SC510N4 SDI
Page 2
JMC Systems Engineering AB www.jmc.se +46-8-82 82 70 info@jmc.se
1 Introduction
SC510N4 SDI is a high-quality, high-performance capture device. It supports up to 4 channels of video inputs with SDI connectors.
2 Specification
SC330 Product Series Hardware Specification
Model
SC510 N4 SDI
Max. FPS
120/100fps @ 1920x1080p
Recording
Mode
Software Compression, Real-Time Mode
Product
Photo
Dimension
140 × 94.5 (mm)
Interface
PCIe x4
Video Input
4 × SDI
Display
Video
Format
YUY2
Display
Video
Resolution
1920×1080p@30/25/24fps
1920×1080i@60/50fps
1280×720p@60/50fps
720×480i@60fps 720×576i@50fps
Recording
Video
Format
MPEG4 / H.264 (Software Compression)
Recording
Video
Resolution
1920×1080p@30/25/24fps
1920×1080i@60/50fps
1280×720p@60/50fps
720×480i@60fps 720×576i@50fps
Audio Input
4 × embedded SDI
Page 3
JMC Systems Engineering AB www.jmc.se +46-8-82 82 70 info@jmc.se
Audio
Format
Stereo / 16-bit / 48000Hz
I/O
16
WatchDog
SDK
VC++ / .NET / VB / V4L2
System Requirement
OS Support
Windows XP / Vista / Windows 7
Linux 2.6.14 or Higher
( 32-bit and 64-bit )
3 Packing List
Item
Amount
SC510N4 SDI Capture Card
1 (piece)
Audio cable
2 (piece)
Watchdog cable
1 (piece)
USB stick or CD with driver
1 (piece)
4 Hardware Installation
Before You proceed
Please note below precautions before any install/uninstall operations:
ALWAYS turn off the system before hardware installation/un-installation.  ALWAYS unplug the power cord from the wall outlet/socket before hardware
installation/un-installation.
ALWAYS touch a safely grounded object or metal object before touching the device.
DO NOT touch any devices before the system is fully off. DO NOT touch any electrical and semiconductor components on the device, especially ICs
on board.
4.1 Card and Driver Installation
Step 1: Turn off the system and unplug power cord from wall outlet/socket.
Step 2: Remove the computer system case cover. Step 3: Plug capture device into an available PCIe slot on motherboard. Step 4: After hardware installation is completed, then install the driver.
Page 4
JMC Systems Engineering AB www.jmc.se +46-8-82 82 70 info@jmc.se
4.2 Signal Source Connection Diagram
4.3 Watchdog cable Installation (optional)
Watchdog function is to reset the PC automatically when the system is crashed on an unknown error.
Loading...