Eclipse PX!
Surround Panning Joystick Controller!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
User Manual for OS X!
"
Eclipse PX User Manual for Apple OS X!
May 1, 2014!
!
Part Number 932134-MAC!
!
©2014 JLCooper Electronics!
142 Arena St, El Segundo, CA, 90245, USA!
!
Phone: +1 (310) 322-9990! ! ! Fax:! +1 (310) 335-0110!
web: ! www.jlcooper.com! ! ! email:! info@jlcooper.com!
!
Nuage Panner and Eclipse PX are trademarks of JLCooper Electronics.!
All other brand names are property of their respective owners.!
Introduction! 4!.........................................................................................
Configuring the Hardware! 5!...................................................................
Software Installation and Setup! 6!..........................................................
If the Panner is Connected Through a Router! 7!
If the Panner is Not Connected Through a Router! 9!
Using the Nuage Panner / Eclipse PX with Nuendo! 11!.........................
Panner Operation in Nuendo! 12!
The Display! 13!
JLCooper Limited Warranty! 14..............................................................
Introduction!
The Nuage Panner and the Eclipse PX are identical functionally. !
The Nuage Panner’s form factor is intended to fit into a Yamaha/Steinberg Nuage
Console System. The labels for its various controls reflect the function of those controls
when used with Steinberg Nuendo software.!
The Eclipse PX is designed to sit on a desktop, and its labels reflect its use as a general
purpose device.!
However, from a software standpoint, they are completely interchangeable.
Consequently, the term “panner” will often be used in this guide to refer to either one.!
Configuring the Hardware!
The unit has an Ethernet Interface that can be configured directly from the front panel of
the unit.!
To configure the Ethernet Interface from the front panel of the unit, do the following:!
1. Turn unit off or remove power plug.!
2. Press and hold the Enable and S1 (⟷) buttons.!
3. Turn unit on or insert power plug.!
4. Release the buttons.!
5. The unit will display the firmware version for a few seconds.!
6. After that, the display shows the first number of the IP address.!
7. To show or modify the first number of the IP address, press the S1 (⟷)
button.!
8. To show or modify the second number of the IP address, press the S2 (↕)
button.!
9. To show or modify the third number of the IP address, press the S3 (⤢)
button.!
10. To show or modify the last number of the IP address, press the S4 (⤡) button.!
11. Turn the encoder labelled E1 or FrontDivergence/Width to adjust the IP
address.!
12. To store the IP address, press the Enable button.!
13. To load the new IP address, power cycle the unit.!
!