INSTALLATION GUIDE
for the
SB-B-X5E70/10W3v3
SKU# 94517
2007 -Up BMW X5
Thank you for choosing a JL Audio Stealthbox® for your automotive sound system. With proper installation, your new
vehicle-specific enclosed subwoofer system will deliver years of listening pleasure.
We strongly recommend that you have your new Stealthbox® installed by your authorized JL Audio dealer. The
installation professionals employed by your dealer have the necessary tools and experience to disassemble and
reassemble your vehicle properly. Also, keep in mind that your warranty coverage extends to 2 years if your system is
installed or approved by your authorized JL Audio dealer. If you prefer to perform your own installation, please read
this installation guide completely
before beginning the process.
If you choose to per form the installation yoursel f, it is abso lutely vital that
the Stealthbox
®
be properly mounted to the vehicle accord ing to these
instructions . Failure to mo unt the enclosure properly present s two problems:
1) The sub-bass per formance will suffer due to the movem ent of the enclosure
caused by the force exe rted by the woofer(s).
2) A loose enclosure pres ents a serious safety haza rd in the event of a collision
or sudden deceleration.
STEP 1
Empty out the cargo area so that you have a clean area to
work in.
Continued on Next Page
STEP 2
Remove the three screws on the b attery cover, and remove
the cover. Remove the screws holding in the storage tray,
and remove the tray.
STEP 3
The tools can be relocated to the foam tray inside the spare
tire.
SB-B-X5E70/10W3v3 INSTR_SKU# 011324
IN STALL ATIO N
DIFFICULTY:
25
OUT
OF
ESTIMATED TIME:
1 HOU R
Continued on Next Page
SB-B-X5E70/10W3v3 INSTR_SKU# 011324
STEP 7
Remove the speed clip from the location indicated by the
left arrow, and relocate it to the location indicated by the
right arrow, as shown.
STEP 6
Using a 1” hole saw, drill a hole at the intersection, and slide
a U-Nut through the driled hole, aligning it with the f actory
hole, as shown.
STEP 5
Note: Steps 5-6 are only necessar y on vehicles not
equipped with the f actory bracket shown in Step 4.
Locate the two holes in the floor, and mark their
perpindicular intersection, as shown.
STEP 4
Remove the nut from the factory bracket, as shown. Retain
the nut for use in St ep 10.
If this factory bracket isn’t present, substitute Steps 5- 6.
Page 2 • JL Audio, Inc 2011
STEP 9
Using a pair of 1/4” - 20 x 1” Bolts, 1/4” Lock Washers, and 1/4”
Flat Washers, attach the Side Bracket to the Stealthbox® as
shown, and hand tighten.
STEP 8
Pictured is the included hardware, along with the fac tory nut
removed from Step 4.
STEP 10
Attach speaker cable to the Stealtbhox®, and place the
enclosure into position, aligning the hole in the Side Bracket
with the factor y bolt, as shown. Secure the Side Bracket to
the floor using the factory nut removed in Step 4.
On vehicles not equipped with the factor y bracket and bolt,
secure the Side Bracket to the U-Nut installed in Ste p 6
using a ****.
STEP 11
Slide the Stealthbox® as far back toward the rear of the
vehicle as possilbe. Using an open- ended wrench, tighten
the two 1/4” - 20 x 1” to secure the Side Bracket to the
Stealthbox®.
Continued on Next Page
SB-B-X5E70/10W3v3 INSTR_SKU# 011324
Page 3 • JL Audio, Inc 2011
STEP 14
Cut the Foam Tape into three 4” strips, affix them to the new
Battery Cover, and trim away the excess, as shown.
CONGRATULATIONS!
You have completed the installation for this model!
Enjoy your new Stealthbox®!
Please refer to the Power Recommendation se ction for an
amplifier recommendation and basic set-up help.
STEP 15
Secure the Batter y Cover using the three #8 x 1” Screws.
STEP 13
Secure the Top Bracket to the Stealtbox® and to the rail using
a pair of 1/4” - 20 x 1” Bolts, 1/4” Lock Washers, and 1/4” Flat
Washers .
STEP 12
Slide a U-Nut over the factory hole in the rail, as shown.
Continued on Next Page
SB-B-X5E70/10W3v3 INSTR_SKU# 011324
Page 4 • JL Audio, Inc 2011
INCLUDED HARDWARE
(4) 1/4” - 20 x 1” Bolt (1) Side Bracket (1) Foam Tape (2) U-Nut
(4) 1/4” Flat Washer (1) Top Bracket (3) #8 x 1” Screw
(4) 1/4” Lock Washer (1) Battery Cover (1) 1/4” - 20 x 1/2” Bolt
SPECIFICATIONS
Enclosure Type: Acoustic Suspensi on (sealed)
Driver Type: 10W3v3-2
Nominal Impedance: 2 ohm
Continuous Power Handling: 500 watts
POWER RECOMMENDATION
JL Audio recommends high quality amplif iers such as the JL Audio XD700/5 or XD300/1. The diagram b elow shows
the recommended crossover settings for the XD300/1. If another amplifier is being use d, please reference this
illustration and use similar set tings on that amplifier.
All JL Audio amplifiers are very versatile audio components. Please consult the owner’s manual for even more
detailed information about installing and tuning your amplifier.
CONNECTIONS
Using quality power, signal, and speaker wire is essential in ensuring the performance of your Stealthbox®.
JL Audio recommends using a 4 AWG power k it such as the XC-PCS4-1B for your Stealthbox® amplifier. Other
kits are available sho uld you be using more than one amplifier. Signal wire such as the JL Audio Premium Audio
Interconnect Cables sho uld be used to provide signal for both channels of the amplifier. JL Audio reccommen ds
using 12AWG speaker wire for subwoofers such as our XC-BCS12-25.
MID/HIGH FREQUENCY DRIVER FITMENT
Front Speaker Size / Locatio n: 4” - Front Doors
Rear Speaker Size / Location: 4” - Rear Door
A StealthMod® is also available for this vehicle.
All specifications are subject to change without notice. “JL Audio®” and the JL Audio logo, “Stealthbox” and the Stealthbox logo are registered
trademarks of JL Audio, Inc. “Ahead of the Curve” and its respective logo is a trademark of JL Audio, Inc.
JLA-SKU# 94517 07.29.2011 • Printed in USA • ©2008 JL Audio, Inc. • U.S. PATENTS: #5,734,734 #5,949,898 #6,118,884 #6,229,902 #6,243,479
#6,294,959 #6,501,844 #6,496,590 #6,441,685 #5,687,247 #6,219,431 #6,625,292 #D472,891 #D480,709 Other U.S. & Foreign patents pending.
For more detailed information please visit us online at www.jlaudio.com.
(954) 443-1100
www.jlaudio.com
10369 NORTH COMMERCE PARKWAY • MIR AMAR, FLORIDA • 33025 • USA
Loading...