JL Audio SB-POL-RGRRZR, SLPK-POL-RZR800 User Manual

SB-POL-RGRRZR INSTR_SKU# 94456

Slampak

I N S T A L L A T I O N G U I D E

for the

SB-POL-RGRRZR

SKU#94456

2009+

Thank you for choosing a JL Audio Slampak® for your side by side sport utility sound system. With

proper installation, your new vehicle-specific enclosed subwoofer system will deliver years of listening

pleasure.

®

We strongly recommend that you have your new Slampak

dealer. The installation professionals employed by your dealer have the necessary tools and experience

to disassemble and reassemble your vehicle properly. Also, keep in mind that your warranty coverage

extends to 2 years if your system is installed or approved by your authorized JL Audio dealer. If you

prefer to perform your own installation, please read this installation guide completely

before beginning the process.

installed by your authorized JL Audio

If you choose to perform the installation yourself, it is absolutely vital that the

®

Slampak
Failure to mount the enclosure properly presents two problems:

1) The sub-bass performance will suffer due to the movement of the enclosure
caused by the force exerted by the woofer(s).

2) A loose enclosure presents a serious safety hazard in the event of a collision
or sudden deceleration.

be properly mounted to the vehicle according to these instructions.

S T E P 1

Unpack the Slampak® mount the two brackets as shown

S T E P 2

There are two each of the pictured clamps, the ones with
the short spacers (un-assembeled in the bag) go directly
in front of the speakers, the ones with the long spacers
(assembeled on the right) are installed from below, there are
also locking pins that are not shown that are available and,
can be put in place through the clamps to keep them in the
locked positions. Make sure that all of the hardware on each
of the clamps is snug so that when the arm is pushed flat,
the rubber section of the clamp is squeezed and expands to
hold the clamp in place.

S T E P 3

Line up the brackets with the existing holes as shown in the
pictures at left and below.

INSTALLATION
D I F F I C UL T Y:

OU T
OF

25

ESTIMATED TIME:
12 HOURS

Continued on Next Page

SB-POL-RGRRZR INSTR_SKU# 94456

S T E P 4

once both compression clamps are in place, fold the lever
down and insert the locking pin.

S T E P 5

This is seen from the rear wheel looking up and to the front,
notice the expansion clamp inserted from below going up
into the enclosure from below. This will be done on each
side then the locking pins need to go into place to secure
the clamp.

S T E P 6

Plug the two jacks for the included harness into the
Stealthbox®

S t e P 8

Looking back from the front, run the cabling through this
access hole near the floor and, secure it as shown in the
DETAIL picture below.

D e t a i l

S t e P 9

Looking down through the battery area, run the cabling
along side the large harness seen at the bottom of the
picture towards the front of the vehicle, secure the cabling as
needed to the main cable that is right next to it.

Page 2 • JL Audio, Inc 2009

S T E P 7

Run the cabling to the outside of the vehicle and secure
using zip-ties as shown, make sure that there is clearence for
the seat so that when it’s in place, the cabling isn’t pinched.

S t e P 1 0

Remove the four screws that hold up the “belly pan” on the
Drivers side of the vehicle, secure the cabling along with the
OEM Harness along this run. When completed, re-install the
removed screws.

Continued on Next Page