JL Audio SB-N-ARMAD-10W6v2-DG2, SB-N-ARMAD-10W6v2, SB-N-ARMDA-10W6v2, SB-N-ARMAD-10W6v2-TN, SB-N-ARMAD-10W6v2-GA User Manual
...
➔
➔
➔
➔
Stealthbox
®
INSTALLATION GUIDE
SB-N-ARMDA/10W6v2, JL AUDIO, Inc 2005
Sheet SKU#011193 Revision 5/26/2005Page 1
for the
SB-N-ARMAD/10W6v2
(2004-Up Nissan Armada, without the power
lift gate)
This Stealthbox is a product which
requires professional installation skills and
tools.
Please read this installation guide thoroughly before beginning the project. It
will guide you step by step through the
installation.Several of the steps in this
process may require two people to
accomplish.
It is absolutely vital that the enclosure
be properly mounted to the vehicle
according to these instructions. Failure
to mount the enclosure properly presents two problems: 1) The sub-bass
performance will suffer due to the
movement of the enclosure caused by
the force exerted by the woofer(s) and
2) A loose enclosure presents a serious
safety hazard in the event of a collision
or sudden deceleration.
Please enjoy your JL Audio Stealthbox
responsibly.
STEP 1:
Clear out any contents from the
cargo area.
STEP 2:
Fold down the third row seating.
STEP 3:
Remove the driver’s side rear stor-
age door and remove the jack.
STEP 4:
Remove the sill plate,floor storage
door and cargo area carpeting.
STEP 5:
There are a pair of tie-down cleats
that need to be removed from the driver’s
side.
Pull the metal loop up and with a flat blade
screw driver pop up the plastic clip.
STEP 6:
Lower the metal loop and feed the
plastic clip through the metal loop.
With a 10mm socket,remove the bolts from
each cleat.
START
HERE
Continued on Next Page ➔
www.jlaudio.com
➔
➔
➔➔
➔➔➔
STEP 7: With a 14mm socket, remove the driver’s side third row seat belt.
STEP 11: With a second person, carefully remove
the lower portion of the dr iver’s side rear panel.
When removing the bottom panel,
Do not let the guides that are found at the top of
the bottom panel scratch the upper panel.
Cont.
From
Previous
Page
Continued on Next Page ➔
➔
STEP 8: With a 14mm open end wrench,
remove the driver side second row seat belt.
STEP 12: With a 10mm socket,remove the 5
bolts that secure the jack bracket.
There are two bolts that are hidden,look down into
the bracket area locate them.
Remove the jack bracket out of the SUV.
STEP 9: Remove the driver’s side rear door sill
plate.
STEP 10: Remove the cargo net loop,that is
found on the driver’s side rear cargo side panel.
With a small flat blade screw driver, pop the front of
the button out. Remove the net loop assembly completely out of the panel.
SB-N-ARMDA/10W6v2, JL AUDIO, Inc 2005
Sheet SKU#011193 Revision 5/26/2005Pag e 2
www.jlaudio.com
STEP 13(A): Cut out the pocket and the jack pass through from the side panel.
Cut below the storage door guide slots. This way the door will still fit, if Stealthbox is
removed.Use tape for a cutting guide.