JL Audio SB-N-350-10W3v3, SB-N-350-10W3v2 User Manual
➔
➔
➔
➔
Stealthbox
®
INSTALLATION GUIDE
SB-N-350/10W3v2, JL AUDIO, Inc 2004
Sheet SKU#011187 Revision 2/11/2004Page 1
for the
SB-N-350/10W3v2
(2003-Up 350Z, Will not fit the 350z
Roadster, Infiniti G35 Coupe & Sedans)
This Stealthbox is a product which
requires professional installation skills and
tools.
Please read this installation guide thoroughly before beginning the project. It
will guide you step by step through the
installation. Several of the steps in this
process may require two people to
accomplish.
It is absolutely vital that the enclosure
be properly mounted to the vehicle
according to these instructions. Failure
to mount the enclosure properly presents two problems: 1) The sub-bass
performance will suffer due to the
movement of the enclosure caused by
the force exerted by the woofer(s) and
2) A loose enclosure presents a serious
safety hazard in the event of a collision
or sudden deceleration.
Please enjoy your JL Audio Stealthbox
responsibly.
STEP 1:
Remove all contents from center
console, rear cargo area, rear glove box compartments, lastly slide and tilt the seats to the
front of the car.
STEP 3:
Remove the driver’s side and pas-
senger’s side door sill panels.
*Carefully pulling directly upward.*
STEP 2:
Remove the driver’s side and passenger’s side rear interior cargo quarter panels.
STEP 4:
Remove the Philip head screws, that
are found on both diver’s side and passenger’s side of the console.
STEP 5:
Remove the two Philip head screws
that have been exposed by the removal of
the ashtray.
START
HERE
Continued on Next Page ➔
www.jlaudio.com
➔
➔
STEP 6: Loosen the shifter trim panel by pulling
directly up. Pull the panel away from the console.
Manual transmission shifter shown in picture, automatic shifter removal maybe slightly different, then
shown.
*Careful not to damage the shifter or
scratch the dash panel. *
➔➔
➔➔➔
STEP 10: Lift at the rear of the console and carefully pull unit over the emergency hand brake arm.
Cont.
From
Previous
Page
Continued on Next Page ➔
➔
STEP 7: Disconnect the white wiring plug at the
rear of the A/C controls.
STEP 11: Disconnect the wiring harness at the
plug located under the center console.
➔
STEP 12: Carefully guide the shifter boot trim
panel through the front opening in the console.This
will allow for full removal of the center console.
*Careful not to damage the shifter boot or
scratch the dash panel. *
STEP 13: Remove the center console, out of the
vehcile.
STEP 8: With the shifter trim panel moved to
one side. Remove the pair of Philip head screws at
the front edge of the console.
STEP 9: Engage the emergency brake, by pulling
up on the handle.
SB-N-350/10W3v2, JL AUDIO, Inc 2004
Sheet SKU#011187 Revision 2/11/2004Pag e 2
www.jlaudio.com
STEP 14: Remove the rear bulkhead front panel,
by carefully pulling towards the front of the vehcile
around the glove box.
Loading...