JL Audio SB-GM-4GSUVCNSL/10TW1 Stealthbox Installation Guide
SB-GM-4GSUVCNSL/10TW1 INSTR _SKU# 011490
If you choose to perform the installation yourself, it is absolutely
vital that the Stealthbox
according to these instructions. Failure to mount the enclosure
properly presents two problems:
1) The sub-bass performance will suffer due to the movement of the
enclosure caused by the force exerted by the woofer(s).
2) A loose enclosure presents a serious safety hazard in the event of a
collision or sudden deceleration.
®
be properly mounted to the vehicle
INSTALLATION
DI FFICU LTY:
OUT
OF
5
1
ESTIMATED TIME:
1 HOUR
INSTALLATION GUIDE
for the
SB-GM-4GSUVCNSL/10TW1
SKU# 94644
2015-Up Chevrolet Tahoe, Suburban, GMC Yukon, Yukon XL
Cadillac Escalade, & Escalade ESV
Enclosure Type: Sealed
Driver Type: 10T W1-2
Nominal Impedance: 2 ohms
Continuous Power Handling: 300 watts (RMS method)
Thank you for choosing a JL Audio Stealthbox® for your automotive sound system.
With proper installation, your new vehicle-specific enclosed subwoofer system
will deliver years of listening pleasure.
We strongly recommend that you have your new Stealthbox® installed by your
authorized JL Audio dealer. The installation professionals employed by your
dealer have the necessary tools and experience to disassemble and reassemble
your vehicle properly. If you prefer to perform your own installation, please read
this installation guide completely before beginning the process.
Continued on Next Page
INCLUDED HARDWARE
SB-GM-4GSUVCNSL/10TW1 INSTR _SKU# 011490
Page 2 • JL Audio, Inc., 2017
No additional hardware required.
Continued on Next Page
SB-GM-4GSUVCNSL/10TW1 INSTR _SKU# 011490
POWER RECOMMENDATION
JL Audio recommends high quality ampliers such as the JL Audio XD300/1v2. The diagram below shows the recommended crossover settings for the XD300/1v2. For a detailed description of the
amplier settings, consult the owner’s manual for the amplier. If another amplier is being used, please reference this illustration and use similar settings on that amplier.
Turn-On Mode
Rem. | Oset | Signal
Monoblock Subwoofer Amplifier
Input Voltage
Low | High
CONNECTIONS
Using quality power, signal, and speaker wire is essential in ensuring the performance of your Stealthbox®. JL Audio recommends using a 4 AWG power kit such as the XD-PCS4-1B for your
Stealthbox® amplier. Other kits are available should you be using more than one amplier. Signal wire such as the JL Audio Premium Audio Interconnect Cables should be used to provide signal for
both channels of the amplier. JL Audio recommends using 12 AWG speaker wire for subwoofers such as our XC-BCS12-25.
Page 3 • JL Audio, Inc., 2017
Continued on Next Page
Loading...