JL Audio SB-F-TRKCTR2-10W3v3, SB-F-TRKCTR-10W3 User Manual
SB-F-TRKCTR/10W3 Stealthbox™
Fits Full-Size Ford Pickup Trucks Equipped
with a Center Console
Installation Guide:
This Stealthbox is a product which requires professional installation skills and tools. Please read this
installation guide thoroughly before beginning the project. It will guide you step by step through the
installation. Several of the steps in this process may require two people to accomplish.
It is absolutely vital that the enclosure be properly mounted to the vehicle according to these instructions. Failure to mount the enclosure properly presents two problems: 1) The sub-bass performance
will suffer due to the movement of the enclosure caused by the force exerted by the woofer and 2) A
loose enclosure presents a serious safety hazard in the event of a collision or sudden deceleration.
STEP 1: Remove the rubber pad & cup holder from the factory center console.
STEP 2: Remove the four nuts holding the console to
the floor. There are two in the front edge and two in the
back edge of the console..
SB-F-TRKCTR/10W3, JL AUDIO, Inc 1999 • Page 1
Cup holder size may differ depending on vehicle
year.
Sheet SKU#011113 Revision 9/4/01
STEP 3: Remove the console from the vehicle.
STEP 4: Cut the carpet between each set of mounting
studs in the vehicle. The Stealthbox should sit directly on
the metal floor of the vehicle.
STEP 5: Remove the six screws holding the outer shell of the console to the storage unit. There are two
screws in the cup holder and two in each side near the bottom of the unit. Remove the outer shell.
STEP 6: Place the outer shell over the Stealthbox. Bolt the shell to the Stealthbox using the six factory
screws.
IMPORTANT: Only screw into the predrilled holes in the Stealthbox, do not drill new holes!
SB-F-TRKCTR/10W3, JL AUDIO, Inc 1999 • Page 2
Sheet SKU#011113 Revision 9/4/01
Loading...