JL Audio SB-F-F1502-10W3v3-GA, SB-F-F1502-10W3v3-TN, SB-F-F1502-10W3v3-BK, ZR570-CSii, SB-F-F1502-10W3v3 User Manual

...

SB-F-F1502/10W3v3

2004 - 2008 Ford F-150 Super Crew & Super Cab

2006 - 2008 Lincoln Mark LT

SB-F-F1502/10W3v3_INSTR_SKU#011251

HOU R

INSTALLATION GUIDE

for the

SB-F-F1502/10W3v3

2004 - 2008 Ford F-150 Super Crew & Super Cab

2006 - 2008 Lincoln Mark LT

Thank you for choosing a JL Audio Stealthbox® for your automotive sound system. With proper

installation, your new vehicle-specific enclosed subwoofer system will deliver years of listening pleasure.

If you choose to perform the installation yourself, it is absolutely vital that the Stealthbox instructions. Failure to mount the enclosure properly presents two problems:

1) The sub-bass performance will suffer due to the movement of the enclosure caused by the force exerted by the woofer(s).

2) A loose enclosure presents a serious safety hazard in the event of a collision or sudden deceleration.

be properly mounted to the vehicle according to these

STEP 1

Remove all contents from the rear seating area.

Lift up both seats.

Remove the jack, jack tools and the jack’s mounting bracket. The jack and the jack tools must be relocated.

STEP 2

Thread a supplied socket cup screw into the driver’s side rear of the Stealthbox®, leaving 1.0” of the threads exposed.

INSTALLATION DIFFICULTY:

OUT OF

ESTIMATED TIME: 1

HOUR

We strongly recommend that you have your new Stealthbox® installed by your authorized JL Audio

dealer. The installation professionals employed by your dealer have the necessary tools and experience

to disassemble and reassemble your vehicle properly. If you prefer to perform your own installation,

please read this installation guide completely

before beginning the process.

STEP 3

Thread another supplied socket cup screw into the passenger’s side rear of the Stealthbox®, leaving 1.0” of the threads exposed.

Continued on Next Page

SB-F-F1502/10W3v3_INSTR_SKU#011251

JLA-SKU#011251-01-24-200

(2)

3/8” -16 x 2-1/4” Socket Cup Set Screw

(2)

3/8” Flat Washer

(2)

3/8” Split Lock Washer

(2)

3/8” -16 Hex Nut

Bass Reflex (ported)

10W3v3-4

4 ohms mono

500 Watts

P O W E R R E C O M M E N D A T I O N

5” x 7” / Front Doors

TR570-CXi, C5-570, C5-570x & ZR570-CS

5” x 7” / Rear Door

TR570-CXi, C5-570, C5-570x & ZR570-CS

STEALTHBOX WALL

THREADED INSERT

STEP 4

INCLUDED HARDWARE

Run speaker wire from the amplifier’s location to the Stealthbox® location and check for proper operation of the woofer.

(2)

3/8” -16 x 2-1/4” Socket Cup Set Screw

(2)

3/8” Flat Washer

(2)

3/8” Split Lock Washer

(2)

3/8” -16 Hex Nut

SPECIFICATIONS

STEP 5

Guide the two socket cup set screws through the existing holes that are located on the rear seat brackets.

Enclosure Type: Driver Type: Nominal Impedance: Continuous Power Handling:

POWER RECOMMENDATION

JL Audio recommends using a high quality amplifier such as the JL Audio 500/1v2.

Bass Reflex (ported)

10W 3v3- 4

4 ohms mono

500 Watts

The diagram below shows the recommended crossover, infrasonic filter and equalizer settings for the 500/1v2 when being used to power your Stealthbox®.

+12VDC Ground Remote Preamp Output Section

500/1v2

Monoblock Subwoofer Amplifier

Output Mode Filter Slope Mode

Full Range | Amp Filter | Out Filter

Left Output Right Output Left Ch. Right Ch.Filter Freq. (Hz) Filter Freq. (Hz)Infrasonic Freq. (Hz) Remote Bass Port

12dB| 24dB

556580

Filter Mode

100

LP| HP

200 15

Infrasonic Filter

“Q” Center Freq. Boost (dB)

1.6

1.1

2.7

304060

0.7

0.5

4.3 20

Bass EQ

223045

Off | On

60 40

80 0

+10

Advanced Bass Control

+13

+15

Amp LP Filter

Mode | Slope

Off | 12dB | 24dB Low | High Off | OnOff | On

556580

100

200

Amplifier Input Section

Input Voltage Input Sens. Signal Sensing

Subwoofer Output

MONO OUTPUT ONLY

STEP 6

REAR SEAT BRACKET

LOCK WASHER

Place a supplied flat washer, lock washer and then hex nut onto each socket cup set screw and secure.

The JL Audio 500/1v2 is a very versatile audio component. Please consult the owner’s manual for even more detailed information about installing and tuning this amplifier.

MID/HIGH FREQUENCY DRIVER FITMENT

HEX NUT

SOCKET CUP SET SCREW

FLAT WASHER

A variety of JL Audio coaxial and component systems will fit in the factory speaker locations of you vehicle.

Front Speaker Size / Location: Fits JL Audio Models:

TR570-CXi, C5-570, C5-570x & ZR570-CSii

5” x 7” / Front Doors

Page 3 • JL Audio, Inc 2007

CONGRATULATIONS

You have completed the installation for this model!

Please refer to the Power Recommendation section for an amplifier recommendation and basic set-up help.

Rear Speaker Size / Location: Fits JL Audio Models:

All specifications are subject to change without notice. “JL Audio®” and the JL Audio logo, “Stealthbox” and the Stealthbox logo are registered trademarks of JL Audio, Inc. “Ahead of the Curve” and its respective logo is a trademark of JL Audio, Inc.

JLA-SKU#011251-01-24-20088 • Printed in USA • ©2007 JL Audio, Inc. • U.S. PATENTS: #5,734,734 #5,949,898 #6,118,884 #6,229,902 #6,243,479 #6,294,959 #6,501,844 #6,496,590 #6,441,685 #5,687,247 #6,219,431 #6,625,292 #D472,891 #D480,709 Other U.S. & Foreign patents pending. For more detailed information please visit us online at www.jlaudio.com.

10369 NORTH COMMERCE PARKWAY • MIRAMAR, FLORIDA • 33025 • USA

5” x 7” / Rear Door

TR570-CXi, C5-570, C5-570x & ZR570-CSii

(954) 443-1100

www.jlaudio.com