JL Audio SB-F-EXPED Installation Manual
➔
➔
➔
➔
Stealthbox
®
INSTALLATION GUIDE
SB-F-EXPED/10W6AE, JL AUDIO, Inc 2004
Sheet SKU#011106 Revision6/29/2004 Page 1
for the
SB-F-EXPED/10W6AE
(1997-2002 Ford Expedition &
1998-2002 Lincoln Navigator)
This Stealthbox is a product which
requires professional installation skills and
tools.
Please read this installation guide thoroughly before beginning the project. It
will guide you step by step through the
installation. Several of the steps in this
process may require two people to
accomplish.
It is absolutely vital that the enclosure
be properly mounted to the vehicle
according to these instructions. Failure
to mount the enclosure properly presents two problems: 1) The sub-bass
performance will suffer due to the
movement of the enclosure caused by
the force exerted by the woofer(s) and
2) A loose enclosure presents a serious
safety hazard in the event of a collision
or sudden deceleration.
Please enjoy your JL Audio Stealthbox
responsibly.
STEP 1:
Remove the tool access panel, from
the passenger’s side rear cargo panel.
Remove all contents.
STEP 2:
Remove the hatch floor sill.
STEP 3:
Remove the cargo hatch ceiling trim.
STEP 4:
Unscrew the pair of cargo net
hooks, from the passenger’ side cargo panel.
STEP 5:
Remove the D-pillar trim.This is the
panel that is directly behind the passenger’s
rear side window.
STEP 6:
Remove the rear passenger’s side
door sill.
START
HERE
Continued on Next Page ➔
www.jlaudio.com
➔
➔
➔➔
➔➔➔
STEP 7: Fold the rear seats forward and remove
the exposed floor trim panel.
STEP 11: Remove the rubber weather seal from
the rear passenger’s door opening.
Cont.
From
Previous
Page
Continued on Next Page ➔
➔
STEP 8: At the rear passenger’s side C-pillar. Lift
the flap covering the upper seat bolt anchor to
expose the mounting bolt.The flap needs to be lifted from the bottom.
STEP 12: Remove the plastic trim off the rear passenger’s side C-Pillar.This is located behind the passenger’s side rear door, in front of the passenger’s
side rear side window.
➔
STEP 13: Remove the large passenger’s side rear
cargo panel.
STEP 14: Using an 8mm socket, remove the pair
of bolts that secures the tool kit partition.
If the vehicle is equipped with the OEM woofer system, also remove at this time.
STEP 9: Using a 15mm socket, remove the
mounting bolt of the upper seat belt anchor.
STEP 10: At the bottom of this seat belt assembly,
lift up on the rubber boot cover.
Use a T-45 socket to remove this lower seat belt
anchor mounting bolt.
SB-F-EXPED/10W6AE, JL AUDIO, Inc 2004
Sheet SKU#011106 Revision6/29/2004 Pag e 2
www.jlaudio.com
Loading...