JL Audio SB-D-CLBR-10W1v2 User Manual

SB-D-CLBR/10W1v2

2007 - Up

Dodge Caliber

SB-D-CLBR/10W1v2_INSTR_SKU#011236

1 HO UR

INSTALLATION GUIDE

for the

SB-D-CLBR/10W1v2

2007 - Up

Thank you for choosing a JL Audio Stealthbox® for your automotive sound system. With proper

installation, your new vehicle-specific enclosed subwoofer system will deliver years of listening pleasure.

Dodge Caliber

If you choose to perform the installation yourself, it is absolutely vital that the Stealthbox instructions. Failure to mount the enclosure properly presents two problems:

1) The sub-bass performance will suffer due to the movement of the enclosure caused by the force exerted by the woofer(s).

2) A loose enclosure presents a serious safety hazard in the event of a collision or sudden deceleration.

be properly mounted to the vehicle according to these

STEP 1

Remove all contents from the cargo area.

STEP 2

Remove the right side rear hold down cleat.

INSTALLATION DIFFICULTY:

OUT OF

ESTIMATED TIME:

1 HOUR

We strongly recommend that you have your new Stealthbox® installed by your authorized JL Audio

dealer. The installation professionals employed by your dealer have the necessary tools and experience

to disassemble and reassemble your vehicle properly. Also, keep in mind that your warranty coverage

extends to 1 year if your system is installed or approved by your authorized JL Audio dealer. If you

prefer to perform your own installation, please read this installation guide completely

before beginning the process.

STEP 3

Pull the plastic flooring and rear sill plate out.

Continued on Next Page

SB-D-CLBR/10W1v2_INSTR_SKU#011236

STEP 4

Remove the right side rear cargo panel out of the car.

STEP 5

Place the supplied wax square into position, as in the picture.

STEP 6

Fully thread the supplied hex bolt into the bottom of the Stealthbox®.

STEP 8

Press down on to the Stealthbox® firmly.

Remove the Stealthbox® carefully, leaving the wax square in place. The hex bolt will leave an impression onto the wax.

STEP 9

Note: Before drilling, make sure that you are not going to be drilling into any gas lines, brake lines, transmission lines, electrical wiring, transfer case (4x4 vehicles) or anything else that might cause a reduction in your weekly pay. Always wear eye protection when drilling!

With a drill and a 1/2-inch drill bit, drill through the impression made in the wax square. Remove the wax square.

STEP 10

Run speaker wire from the amplifier location to the Stealthbox® location and check for proper operation of the woofer.

Page 2 • JL Audio, Inc 2007

STEP 7

Position the Stealthbox® into place.

This mounting area is a tight fit. The Stealthbox® needs to angle into the mounting area. Start by sliding the rear of the Stealthbox ® into the mounting area. Then turn the Stealthbox® clockwise.

STEALTHBOX WALL

FENDER WASHER

FLAT WASHER

LOCK WASHER

THREADED INSERT

VEHICLE SHEET METAL

HEX HEAD BOLT

Back out the hex bolt that was installed in Step 6.

Place the Stealthbox® back into the mounting area.

STEP 11

Place the supplied lock washer, flat washers and then fender washer onto the hex bolt. From under the car place the hex bolt assembly up through the floor and into the threaded insert on the bottom of the Stealthbox®. Secure the bolt assembly.

Note: For added protection, it is recommended that you apply a bead of silicone between the vehicle and the fender washer. After the bolt assembly is tightly secured, it is also recommended that vehicle undercoating material is applied to the exposed assembly.

Continued on Next Page

+ 1 hidden pages