JK Audio Daptor One User Manual

Warranty

The model Daptor One is covered by a 2 year
warranty to be free from defective workmanship
and materials. In the event that the Daptor One
needs repair, you must call us to get an
authorization, and then carefully pack and ship
it to us. You will pay for shipping to us and we
will pay for return back to you, UPS ground. No
free repairs will be made if the defect was
caused by misuse, weather conditions, or other
cause, except for defective workmanship or
materials. THERE ARE NO EXPRESSED OR
IMPLIED WARRANTIES WHICH EXTEND
BEYOND THE WARRANTY HERE MADE.

06/06

JK Audio, Inc. 1311 E 6th Street, Sandwich, IL 60548 USA

Voice: [phone] Toll Free: 800-JK-Audio

Fax: [phone]

[e-mail] www.jkaudio.com

Copyright © 2006 JK Audio, Inc. All Rights Reserved

Daptor One

Wireless Phone Adaptor

User Guide

JK Audio

Description

Specifications

Daptor One is a simple interface that converts
the 2.5mm headset jack on your wireless cellu­lar phone to a modular phone line jack. This
modular RJ-11 jack then connects directly to
any JK Audio RemoteMix series mixer. You will
continue to use your wireless phone to dial or
answer the call, but you will use the microphone
and headphones plugged into your RemoteMix
during the call.

Daptor One does not require any batteries or
power supply. It contains a mini hybrid circuit
that converts the earpiece and microphone sig­nals into a balanced RJ11 phone line signal.
The mic signals from the RemoteMix are sent
into the wireless phone, while the earpiece sig­nals from the wireless phone are sent into the
RemoteMix Headphones. The hybrid circuit
minimizes crosstalk between transmit and re­ceive which would create unwanted echo on
both the RemoteMix and far side of the call.

RemoteMix
Phone Line Jack: RJ-11

12” modular cord provided

Wireless
Headset Jack: ¼” - 3 conductor

36” cable provided
(¼”- 3 conductor to

2.5 mm 3 conductor)
Size: 3.6” x 1.6” x 1.3”

(9.2 x 4.1 x 3.3 cm)
Weight: 7 ounces

.

2

7

FAQ’s

Connection

? Will Daptor One work with my model

_______ cell phone?

! As long as your wireless phone has a 2.5

mm earpiece jack and accepts a generic
3rd party earpiece or headset, you should
be OK.

? Can I use the Daptor One with my mo-

dem?

! No. Daptor One was designed for JK Au-

dio RemoteMix series mixers only. It does
not provide the necessary talk battery or
ring voltage required by modems, fax ma­chines or other manufacturers remote mix­ers.

Connect the enclosed modular phone line cord
between the Phone Line jack of your Re­moteMix and the phone line jack on Daptor
One. Then connect the enclosed audio
adapter cord between Daptor one and your
wireless phone headset jack.
On your RemoteMix unit, switch on the power
and then switch the Phone Line switch to "Dial /
Talk". You may now place or receive a call us­ing the buttons on your wireless phone.

Note: Wireless phones generate substantial radio fre­quency (RF) noise during a call which can easily leak
into microphone cables, headphone cables, even the
RemoteMix housing. Be sure to keep the wireless phone
one to two feet from the RemoteMix unit. It is also im­portant to keep the wireless adapter cord away from any
other audio cords.

6

3

Connection

Compatibility

Daptor One will provide the highest quality
connection possible between your RemoteMix
unit and cellular telephone. However, due to
the unpredictable nature of wireless telephone
service we cannot guaranty excellent audio
quality every time Daptor One is used. Audio
quality is still mostly dependent upon the con­nection provided by your wireless telephone
service. You should keep in mind that your
wireless telephone also has level control. If
you are having level problems that cannot be
corrected with the controls on the RemoteMix
unit, try adjusting the level on the wireless tele­phone itself.

Daptor One will work with the following JK Au­dio products:

RemoteMix C+
RemoteMix 3
RemoteMix 3.m
RemoteMix Sport
RemoteMix 3x4
innkeeper 1 and 1x Digital Hybrids

4

This product was designed to take advantage
of the increasing number of wireless phones
that accept third party headsets and earpiece
headsets. We've designed a circuit which
emulates the electrical characteristics of these
headsets. Daptor One should work with all
wireless phones that accept generic third
party headsets. While some wireless phones
have the 2.5 mm jack directly on the phone,
others require a headset adapter which con­verts their proprietary connector into the

2.5mm jack. JK Audio does not supply these
adapters. You must contact your wireless
dealer or try your local electronics store.

Other product Compatibility:

Before you get any ideas, Daptor One does
not supply the necessary ring voltage or talk
battery which may be required by modems or
other manufacturers' remote consoles.
This product is approved for use with JK Au­dio RemoteMix series mixers and Digital Hy­brids only.

5