JJC RM-E9 User Manual

JJC RM-E9

Long Range Infrared Remote Control Instruction

Thank you for purchasing JJC RME9 long range Infrared Remote Control. For the best
performance, please read this instruction carefully before use

z To use RM-E9 Remote Control

1. For the first time use, please pull out the plastic separator (if your remote control has
it) at the battery holder.

2. Mount the camera on a tripod (recommended) or place the camera on a stable, level
surface.

3. Press the button and rotate main command dial until (delayed remote) or (quick

1

response remote) is displayed in the control panel.

4. Aim the transmitter on the remote control at the infrared receiver on the camera
(usually within +/- 20 degree of the lens axis, from the left to the right and from the top
to the bottom) and press the shutter-release button on the remote control (when using
the remote outdoors, make sure that the subject is not backlit and that the line of site
between the transmitter and the infrared receiver is not blocked by the lens or other
obstacles).

5. How the camera focuses and shoots depends on the option selected for your
camera's custom setting. For further information, check your camera's manual.

6. Infrared cannot be seen by human eyes. So you will see no visible light from the LED
on the front end of the remote control when operating.

Copyright of JJC Technology Company

1

For further information, check your camera's manual.

1

z Identifying the buttons

z Specification

• Easy-to-replace CR2025 lithium battery.

• Operating temperature: 5 °C to 40 °C (40 °F to 105 °F).

• Typical Battery Life: up to 3 years, 20,000 exposures.

• Operation distance: 1cm-20meters.

• Dimension: 86 X 40 X 11.5 MM

• Weight: 22g

z To Replace the Battery

1. The remote control is powered by a three-volt CR2025 lithium battery which is
already included in.

2. After sliding the latch in the direction shown to unlatch the battery holder, remove
the holder.

3. Remove the battery from the battery holder.

4. Insert a fresh battery with the face marked "+" on top.

5. Slide the battery holder into the remote until the latch clicks into place.

Copyright of JJC Technology Company

2