JJC RM-E7 User Manual

JJC RM-E7 Infrared Remote Control Instruction

Thank you for purchasing JJC RM-E7 Infrared Remote Control, For the best performance,
please read this instruction carefully before use.

z To use RM-E7 Remote Control

1. For the first time use, please pull out the plastic separator (if your remote control
has it) at the battery holder.

2. Mount the camera on a tripod (recommended) or place the camera on a stable,
level surface.

3. Press the button and rotate main command dial until (delayed remote) or (quick
response remote) is displayed in the control panel.

4. Aim the transmitter on the remote control at the infrared receiver on the camera
(usually within +/- 20 degree of the lens axis, from the left to the right and from the
top to the bottom) and press the shutter-release button on the remote control
(when using the remote outdoors, make sure that the subject is not backlit and
that the line of site between the transmitter and the infrared receiver is not blocked
by the lens or other obstacles).

5. How the camera focuses and shoots depends on the option selected for your
camera's custom setting. For further information, check your camera's manual.

6. Infrared cannot be seen by human eyes. So you will see no visible light from the
LED on the front end of the remote control when operating.

z To Replace the Battery

Copyright of JJC Technology Company

1

1. The remote control is powered by a three-volt CR2032 lithium battery which is
already included in.

2. After sliding the latch in the directi on showing how to unlatch the battery holder,
remove the holder.

3. Remove the battery from the battery holder.

4. Insert a fresh battery with the face marked "+" on top.

5. Slide the battery holder into the remote until the latch clicks into place.

z Specification

• 100% compatible with Pentax Remote E infrared remote controls.

• Works with all remote shutter release control modes (Quick-response, W/T

Zoom).

• Easy-to-replace CR2025 lithium battery.

• Operating temperature: 5 °C to 40 °C (40 °F to 105 °F).

• Typical Battery Life: up to 3 years, 20,000 exposures.

z Care and Storage

1. When the remote control is not in used for an extend period of time, please
remove the battery from the remote control.

2. Do not leave the remote control in any places exposed to excessive heat, humidity

3. Do not leave remote control on or near a television, refrigerator, or other appliance
with a magnetic field.

4. If the remote control gets wet, wipe it with a dry towel as soon as possible.

5. Do not use orga nic solvents, such as alcohol or paint thinner when cleaning the
remote control.

Compatible with Pentax Cameras

K110D K100D K10D *ist DL K20D K200D

Digital

SLR

KM K2000 K-x K7

*ist DS *ist D *istDS2 *istDL2

S S4 S4i S5i S5n S6

Optio

S7 430 450 550 750z S50

S40 SV 330 A10 A20 A30

Film SLR

*ist MZ6 MZ-L ZX-L

Compatible with Samsung Cameras

Digital SLR

GX-1L GX-1S GX-10 GX-20

Copyright of JJC Technology Company

2