JJC RM-E6A User Manual
JJC RM-E6A
Infrared Remote Control Instruction
Thank you for purchasing JJC RM-E6A Infrared Remote Control. For the best performance, please
read this instruction carefully before use. RM-E6A replaces Canon RC-1 Infrared Remote
Control
z Identifying the buttons
Button for camera shutter.
S
2S
z To Use RM-E6A Remote Control
1. Before using the remote, please remove the plastic separator (if your remote control has) from
the battery holder.
2. Mount the camera on a tripod (recom m ended) or place the camera on a stable, level surface.
3. Set your camera for delayed remote or quick response remote
4. Aim the remote control at the infrared receiver on the camera (usually within +/- 20 degree of
the lens axis, from the left to the right and from the top to the bottom) and press the
shutter-release button on the remote control (when using the remote outdoors, make sure that
the subject is not backlit and that the line of site between the transmitter and the infrared
receiver is not blocked by the lens or other obstacles).
5. How the camera focuses and shoots depends on the option selected for your camera's custom
setting. For further information, check your camera's manual.
6. Infrared cannot be seen by human eyes. So you will see no visible light from the LED on the
front end of the remote control when operating.
z Specification
Button for 2 seconds delay shutter.
1
.
1
For more information please read your camera instruction.
1
• 100% compatible with CANON RC-1, RC-5 infrared remote control.
• Easy-to-replace CR2025 lithium battery.
• Operating temperature: 5 °C to 40 °C (40 °F to 105 °F).
• Typical Battery Life: up to 3 years, 20,000 exposures.
• Operation distance: 1cm-8meters.
z To Replace the Battery
1. The remote control is powered by a three-volt CR2025 lithium battery which is included.
2. Slide the battery holder according to the direction instruction marked on the remote.
3. Remove the battery from the battery holder.
4. Insert a fresh battery with the face marked "+" on top.
5. Slide the battery holder back into the remote.
z Care and Storage
1. When the remote control is not in used for an extend period of time, please remove the
battery from the remote control.
2. Do not leave the remote control in any places exposed to excessive heat, hum idity
3. Do not leave remote control on or near a television, refrigerator, or other appliance with a
magnetic field.
4. If the remote control gets wet, wipe it with a dry towel as soon as possible.
5. Do not use organic solvents, such as alcohol or paint thinner when cleaning the remote
control.
RM-E6A Compatible with Cameras
300D 350D 400D 450D 500D
Digital SLR
Film SLR
APS SLR
SureShot
(Prima Super)
ELPH
REBEL XSI KISS X2 Digital Rebel Digital Rebel XT Rebel T1i
5D Mark II EOS 7D 550D Rebel T2i
ELAN 7 10 30 33 50
55 100 300v 300x 3000v QD
Rebel K2 Rebel T1 Date Rebel T2 Date Kiss III Kiss III L
EOS IX
Z180u Z155 120
370Z Z3
Copyright of JJC Technology Company
2
Loading...