JJC RM-E6 User Manual

JJC RM-E6 Infrared Remote Control Instruction

Thank you for purchasing JJC RM-E6 Infrared Remote Control, for the best performance, please
read this instruction carefully before use.

z To use RM-E6 Remote Control

1. For the first time use, please pull out the plastic separator (if your remote control has it) at the
battery holder.

2. Mount the camera on a tripod (recommended) or place the camera on a stable, level surface.

3. Press the button and rotate main command dial until (delayed remote) or (quick response
remote) is displayed in the control panel.

4. Aim the transmitter on the remote control at the infrared receiver on the camera (usually
within +/- 20 degree of the lens axis, from the left to the right and from the top to the bottom)
and press the shutter-release button on the remote control (when using the remote outdoors,
make sure that the subject is not backlit and that the line of site between the transmitter and
the infrared receiver is not blocked by the lens or other obstacles).

5. How the camera focuses and shoots depends on the option selected for your camera's
custom setting. For further information, check your camera's manual.

6. Infrared cannot be seen by human eyes. So you will see no visible light from the LED on the
front end of the remote control when operating.

z To Replace the Battery

Copyright of JJC Technology Company

1. The remote control is powered by a three-volt CR2032 lithium battery which is already
included in.

2. After sliding the latch in the direction showing how to unlatch the battery holder, remove
the holder.

3. Remove the battery from the battery holder.

4. Insert a fresh battery with the face marked "+" on top.

5. Slide the battery holder into the remote until the latch clicks into place.

z Specification

• 100% compatible with Pentax Remote E infrared remote controls.

• Works with all remote shutter release control modes (Quick-response, W/T Zoom).

• Easy-to-replace CR2025 lithium battery.

• Operating temperature: 5 °C to 40 °C (40 °F to 105 °F).

• Typical Battery Life: up to 3 years, 20,000 exposures.

z Care and Storage

1. When the remote control is not in used for an extend period of time, please remove

the battery from the remote control.

2. Do not leave the remote control in any places exposed to excessive heat, humidity

3. Do not leave remote control on or near a television, refrigerator, or other appliance

with a magnetic field.

4. If the remote control gets wet, wipe it with a dry towel as soon as possible.

5. Do not use organic solvents, such as alcohol or paint thinner when cleaning the

remote control.

z Canon DSLR/SLR part compatible with Canon Cameras

300D 350D 400D 450D 500D

Digital SLR

REBEL XSI KISS X2 Digital Rebel Digital Rebel XT Rebel T1i

5D Mark II EOS 7D 550D Rebel T2i

ELAN 7 10 30 33 50

Film SLR

55 100 300v 300x 3000v QD

Rebel K2 Rebel T1 Date Rebel T2 Date Kiss III Kiss III L

APS SLR
SureShot

(Prima Super)

ELPH

EOS IX

Z180u Z155 120

370Z Z3

z Canon DC part compatible with Canon Cameras

Pro 1 G6 G5 G3

Power Shot

G2 G1 S1 IS S70*

S60* Pro 90 IS

*Only work with shutter function.

Copyright of JJC Technology Company