JJC RM-E2 User Manual

JJC RM-E2

Infrared Remote Control Instruction

Thank you for purchasing JJC RME2 Infrared Remote Control, for the best performance,
please read this instruction carefully before use.

z To use RM-E2 Remote Control

1. For the first time use, please pull out the plastic separator (if your remote control has it) at
the battery holder.

2. Mount the camera on a tripod (recommended) or place the camera on a stable, level
surface.

3. Press the button and rotate main command dial until (delayed remote) or (quick response
remote) is displayed in the control panel.

4. Aim the transmitter on the remote control at the infrared receiver on the camera (usually
within +/- 20 degree of the lens axis, from the left to the right and from the top to the
bottom) and press the shutter-release button on the remote control (when using the
remote outdoors, make sure that the subject is not backlit and that the line of site
between the transmitter and the infrared receiver is not blocked by the lens or other
obstacles).

5. How the camera focuses and shoots depends on the option selected for your camera's
custom setting. For further information, check your camera's manual.

6. Infrared cannot be seen by human eyes. So you will see no visible light from the LED on
the front end of the remote control when operating.

z To Replace the Battery

1

1. The remote control is powered by a three-volt CR2025 lithium battery which is
already included in.

2. After sliding the latch in the direction shown to unlatch the battery holder, remove the
holder.

3. Remove the battery from the battery holder.

4. Insert a fresh battery with the face marked "+" on top.

5. Slide the battery holder into the remote until the latch clicks into place.

z Specification

z 100% compatible with Nikon MLL3 infrared remote controls..
z Easytoreplace CR2025 lithium battery.
z Operating temperature: 5 °C to 40 °C (40 °F to 105 °F).
z Typical Battery Life: up to 3 years, 20,000 exposures.
z

1 When the remote control is not in used for an extend period of time, please remove
the battery from the remote control.
2 Do not leave the remote control in any places exposed to excessive heat, humidity
3 Do not leave remote control on or near a television, refrigerator, or other appliance
with a magnetic field.
4 If the remote control gets wet, wipe it with a dry towel as soon as possible.
5 Do not use organic solvents, such as alcohol or paint thinner when cleaning the
remote control.

Compatible with NIKON Cameras

Digital SLR

Film SLR F65 F75 N65 N75

Coolpix 9000 8800 8400 P6000

LiteTouch 150ED 140ED 130ED 110S 100W

Nuvis Nuvis S

D3000 D5000 D90 D80 D70s

D70 D60 D50 D40 D40x

Copyright of JJC Technology Company

2