Page 1
JJC RM-E1
Infrared Remote Control Instruction
Thank you for purchasing JJC RM-E1 Infrared Remote Control. For the best performance, please
read this instruction carefully before use.
z To use RM-E1 Remote Control
1. For the first time use, please pull out the plastic separator (if your remote control has it) at the
battery holder.
2. Mount the camera on a tripod (recom m ended) or place the camera on a stable, level surface.
3. Press the button and rotate main command dial until (delayed remote) or (quick
response remote) is displayed in the control panel. 1
4. Aim the transmitter on the remote control at the infrared receiver on the camera (usually within
+/- 20 degree of the lens axis, from the left to the right and from the top to the bottom) and
press the shutter-release button on the remote control (when using the remote outdoors, make
sure that the subject is not backlit and that the line of site between the transmitter and the
infrared receiver is not blocked by the lens or other obstacles).
5. How the camera focuses and shoots depends on the option selected for your camera's custom
setting. For further information, check your camera's manual.
6. Infrared cannot be seen by human eyes. So you will see no visible light from the LED on the
front end of the remote control when operating.
Copyright of JJC Technology Company
1
For further information, check your camera's manual.
1
Page 2
z Identifying the buttons
Button for camera shutter.
S
Side for telephoto
T
Side for wide-angel
W
Move forward (replay mode)
+
Move Backward (replay mode)
-
z Specification
• Easy-to-replace CR2025 lithium battery.
• Operating temperature: 5 °C to 40 °C (40 °F to 105 °F).
• Typical Battery Life: up to 3 years, 20,000 exposures.
• Operation distance: 1cm-5meters.
z To Replace the Battery
1. The remote control is powered by a three-volt CR2025 lithium battery which is already
included in.
2. After sliding the latch in the direction shown to unlatch the battery holder, remove the
holder.
3. Remove the battery from the battery holder.
4. Insert a fresh battery with the face marked "+" on top.
5. Slide the battery holder into the remote until the latch clicks into place.
z Attention
a. When the remote control is not in use over a long time, please remove the battery from the
remote control.
b. Do not leave the remote control in places subject to extremely high temperatures.
Copyright of JJC Technology Company
2
Page 3
RM-E1 compatible with Olympus cameras
E1 E3 E10 E20 E30
Digital SLR
Design &
Performance
Easy & Fun
Power &
Versatility
Stylish
E100 RS E300 E330 E400 E410
E420 E450 E510 E520 E620
E600 E-P1 E-P2
Stylus 800 Stylus 500 Stylus 410 Stylus 400 Stylus 300
D40 ZOOM
C8080 Wide
Zoom
C7070 Wide
Zoom
C5000 Zoom C50 Zoom C4040 Zoom
C3000 Zoom C2500L
C2000 Zoom
µ800 Digital µ500 Digital µ410 Digital µ400 Digital µ300 Digital
Copyright of JJC Technology Company
C770 Ultra
Zoom
C7000 Ultra
Zoom
C755 Ultra
Zoom
C60 Zoom
C2100 Ultra
Zoom
C750 Ultra
Zoom
C5060 Wide
Zoom
C3040 Wide
Zoom
C2040 Zoom
C730 Ultra
Zoom
C5050
Zoom
C3030
Zoom
C2020
Zoom
3
Loading...