Thank you for purchasing JJC JR series infrared controller. For the best performance, please read
this instruction carefully before using.
Package Content:
z JR Transmitter
z JR Receiver
z JR Connecting cord
z CR-2032 Battery
z Mini Screwdriver
z Manual Instruction
Transmitter
Receiver
Connecting cord
Screwdriver
Parts of the Transmitter and Receiver
Battery CR-2032
1
To replace the Battery
Transmitter
2
Receiver
3
1. Both JR Receiver and Transmitter are powered by one CR-2032 battery which is already
included in package.
2. Open the battery cover at the back of remote controls.
3. Insert the fresh battery; please ensure the batteries are put into a correct direction.
4. Close the battery cover
Wireless Shutter Setup
4
1. Turn off the camera and attach the JR receiver to a compatible camera’s accessory shoe.
2. Remove the remote socket cap from camera body and take out a connecting cord from the box.
3. Connect the connecting cord to the camera body and the remote socket of JR receiver.
4. Turn on the camera and mount the camera on a tripod or place the camera on a stable, level
surface.
5. Make sure the Control mode dial on the O section.
6. Use the JR transmitter and point to the JR infrared receiver to enjoy wireless trigger.
Instant Shutter
1. Connect the connecting cord to the camera body and receiver remote socket.
2. Shift the Function mode dial to “· “
3. Press the JR transmitter shutter button for one second.
4. The receiver will take a photo instantly.
Delay Shutter*
1. Connect the connecting cord to the camera body and receiver remote socket.
2. Shift the Function mode dial to “·· “
3. Press the JR transmitter shutter button for one second.
4. The receiver status light will flash.
5. The receiver will take a photo after 2 seconds.
*Delay Shutter does not work with Panasonic and Leica cameras.
Remote Cord Function Setup
BLUB
z Select the BLUB mode from the camera.
5
z Connect the connecting cord to the remote socket of camera body and JR transmitter remote
socket.
z Shift the Control mode dial from O to F, camera do the focus.
z Shift the Control mode dial from F to S, camera lock the shutter.
z Shift the Control mode dial from S to O, release the shutter.
Normal Remote Switch Function
1. Connect the connecting cord to the camera body remote socket and JR transmitter remote
socket.
2. Check the Control mode dial on the O section.
3. Turn on the camera.
4. Half press the shutter button for focus, complete press the shutter button for shutter.
For Inbuilt Remote Control Receiver Cameras1
1. Mount the camera on a tripod (recommended) or place the camera on a stable, level surface.
2. Turn on the remote control function of camera.
3. Make sure the Function mode dial on the O section and the control mode dial on “ · “section.
4. Aim the transmitter on the remote control at the infrared receiver on the camera (usually within
+/- 20 degree of the lens axis, from the left to the right and from the top to the bottom) and press
the shutter button on the transmitter (when using the transmitter outdoors, make sure that the
object is not backlit and that the line of site between the transmitter and the infrared receiver is
not blocked by the lens or other obstacles).
5. How the ca mera focuses and shoots depends on the option selected for your camera's custom
setting. For further information, check your camera's manual.
6. Infrared cannot be seen by human eyes. So you will see no visible light from the LED on the front
end of the remote control when operating.
Operating range
For JR Transmitter with JR Receiver maximum operating ranges up to 8Meters.
For JR Transmitter with Cameras inbuilt IR receiver maximum operating ranges 3Meters-10Meters
Specifications
JR Receiver:
2
• Battery Type: 1x CR-2032 battery.
• Operating temperature: 5 °C to 40 °C (40 °F to 105 °F).
• Net Weight Approximately: 26 g
• Dimensions: 50 X39 X 14 mm
JR Transmitter:
•Battery Type: 1x CR-2032 battery.
1
For the cameras compatible with JR transmitter, please check the JR transmitter table.
2
The Operation ranges For CANON camera is about 3meters-5meters. NIKON camera is about 10meters.
6
• Operating temperature: 5 °C to 40 °C (40 °F to 105 °F).
• Net Weight Approximately: 25 g
• Dimensions: 60 X 32 X 12 mm
JR Remote cord:
• Length of cord: approximately 80cm
z Attention:
• When the JR infrared controller is not used over a long time, please remove the battery from
the transmitter and receiver.
• Do not leave the remote controls in place subject to extremely high temperature.
• The operable range of the wireless controller will shorten when the battery is weak.
JR-A compatible with Canon
EOS 5D EOS 1D EOS 1D Mark IIEOS 1Ds EOS 1Ds Mark II
Canon
EOS 1Ds Marks III EOS 20D EOS 10D EOS D60 EOS D30
EOS 30D EOS 5D EOS 1V EOS 3 EOS D2000
EOS 50D EOS 5D Mark IIEOS 7D EOS 1D Mark IV
JR-B compatible with Nikon/ Kodak/ Fujifilm
D2H D1x D1h D1
D2x *D100 D200 F5
Nikon
Kodak DCS-14n
Fuji Finepix S5pro Finepix S3pro
D2Xs D700 D3x D300s
D3s
F6 F100 F90 F90x
JR-C compatible with Canon/ Pentax/ Contax/ Samsung
Digital Rebel XSi Digital Rebel XTi EOS Digital Rebel XT EOS Digit al Rebel EOS 450D
EOS 400D EOS 350D EOS 300D EOS 10 EOS 10S
EOS 100 EOS Elan EOS 30 EOS Elan 7E EOS 7
EOS 30V EOS Elan 7NE EOS 7s EOS 33 EOS Elan 7
EOS 33V EOS Elan 7N EOS 50 EOS Elan II EOS 50E
EOS Elan IIE EOS 55 EOS IX
PENTAX Cameras
K7 K100D K110D K200D K110D SUPER
KM K2000 Optio 20 Optio A10 K10D
K20D *ist DL *ist DS *ist D *ist DS2
*ist DL2 *ist MZ6 MZ-L ZX-L
Optio S Optio S4 Optio S4i Optios S5i Optio S5n
Optio S6 Optio S7 Optio S7 Optio 430 Optio 450
Optio 550 Optio 750z Optio S50 Optio S40 Optio SV
Optio 330
SAMSUNG Cameras
GX-1L GX-1S GX-10 GX-20
SONY Cameras
A230 A330 A380 A450 A700
A850 A900
NIKON Cameras
D3000 D5000 D90 D80 D70S
D70 D60 D50 D40x D40
F65 F75 N65 N75 COOLPIX
8800
COOPLIX 8400 Lite Touch 150ED Lite Touch 140ED Lite Touch 130ED Lite Touch